Winegard AS-2053 - Manuals

Winegard AS-2053 – Manual in PDF format online.

Manuals:

Manual

Manual Winegard AS-2053

Summary

Page 2 - CAUTION; RISK OF ELECTRIC SHOCK; IMPORTANT SAFEGUARDS

2 WARNING: TO REDUCE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE TO RAIN OR MOISTURE. (Not applicable to mount and antenna) CAUTION: TO REDUCE RISK OF ELECTRICAL SHOCK, DO NOT REMOVE COVER, NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL Dangerous voltageinside enclosure...

Page 3 - Table of Contents; OPERATION; FCC PART 15 STATEMENTS; Tools needed for installation:

3 Table of Contents OPERATION Introduction ...................................................................................................................................................... 4Wallplate Control Panel ....................................................................................

Page 4 - DIRECTV; Introduction; Introduction/How Does Digital Satellite TV Work?; ANTENNA

4 DIRECTV ® - 1-800-DIRECTV (1-800-347-3288) ExpressVu - 1-888-SKYDISH (1-888-759-3474) Your new Winegard RV Digital Satellite Unit is aneasy-to-install, easy-to-use satellite TV reception sys-tem. Because it mounts on the top of yourrecreational vehicle, it goes where you go and pro-vides quality r...

Page 5 - Wall plate control panel description, wiring hookup diagrams; Interior connections for one and two receivers; ONE RECEIVER HOOKUP; WINEGARD; SATELLITE SYSTEM

5 OFF: Turns system power off when pressed. PARK: Puts dish in park position. Wall plate control panel description, wiring hookup diagrams ON: Turns system power on when pressed. SEARCH: Acquires GPS signal and locates desiredsatellite signal. LED also lights when dish is moving. RED LEDs (4): Indic...

Page 6 - System Operation

6 System Operation BEFORE parking and leveling vehicle , look for trees, buildings, hills or mountains that might block the satellitesignal and result in poor signal reception. ABOUT YOUR RECEIVER (The unit is factory presetto find 119°W (DISH Network): If you have a DISH Network TM receiver, be sur...

Page 7 - Control Panel Operation; POWER ON; tant; NOTE; PARKING; press

7 2. After successful GPS acquisition, the ON LED will come back onand the SEARCH LED willremain on, indicating the unit isnow moving in the search routineand actively seeking the desiredsatellites. When ON and SEARCH LEDs are on at the same time, Control Panel Operation SEARCH/ MOVING WINEGARD ON O...

Page 8 - Control Panel Operation/Check Switch Routine; DIRECTV programming; “Oval Dish 2 Satellites”; ODD EVEN ODD EVEN; satellite receiver

8 Control Panel Operation/Check Switch Routine Performing Check Switch routine to enable satellite toggle function used withmulti-satellite programming DISH Network programming (DISH 500) NOTE: Once these steps have been completed, youwill not need to perform this test again, unless checkswitch was ...

Page 9 - INSTALLATION

Page 11 - Installation requirements

11 Installation requirements FIGURE 1 FIGURE 3 To install the Winegard Automatic Digital Satellite Dish,check with your RV dealer or manufacturer. Your RV mayalready be pre-wired for this system, and/or may have a re-inforced roof area available.1. Choose a location on the roof that will allow the d...

Page 12 - FIGURE 6; FIGURE 6A

12 FIGURE 6 CENTER LINE OF COACH ROOF The length of this cable MUST BE 53 inchesfrom back of electronics housing to clamp. NOCLAMPS ALONG THIS 53” LENGTH! FRONT OF VEHICLE The length of this cable MUST BE 53 inchesfrom back of electronics housing to clamp. NOCLAMPS ALONG THIS 53” LENGTH! FRONT OF VE...

Page 13 - Roof installation

13 1. Position the roof template on the vehicle roof and drill 1/8” holes for the screws. DO NOT drill clear through into interior of vehicle . The screws fasten mount to the roof only. Be sure the roof can securely hold system. 2. Place base plate gasket under the base before screwing unit down. Se...

Page 14 - BEFORE BEGINNING INSTALLATION, REFER TO DRAWING; EXTERNAL GPS INSTALLATION

14 GPS wire36” long Roof installation The length of this cable MUST BE 53 inchesfrom back of electronics housing to clamp. NOCLAMPS ALONG THIS 53” LENGTH! First cableclamp here! CENTER LINE OF COACH ROOF The length of this cable MUST BE 53 inchesfrom back of electronics housing to clamp. NOCLAMPS AL...

Page 15 - TEST UNIT TO BE SURE IT OPER-; BEFORE; YOU

15 15. BEFORE YOU INSTALL THE BASE COVER, you must SET THE SWITCHES in the outside unit. Decide which programming you will be using.This will determine how you set your switches.To set the switches for the satellite used by yourprogramming provider, remove the small plateon the side of the electroni...

Page 16 - Mounting interior wall plate controller; DO NOT

16 4. Mount the wall plate controller flush with the wall or inside a cabinet. Push the wire harness through the hole, connect to the wall plate and secure screws.You can also use the surface mount box (provided), Figure 12.When using mount box, you mayhave to knock out the portionof the box indicat...

Page 17 - Wiring; DO NOT HOOK UP ORANGE WIRE.; For proper operation:; Check Switch function and toggling between satellites

17 Wiring Wiring the system: This unit requires a +13.8 VDC fused circuit. Unit draws up to 3 amps. The unit uses sophisticated micro-processor technology and needs “clean” (filtered) power to function properly. DO NOT USE power designated to operate a +12 VDC lighting circuit from the converter, or...

Page 18 - Antenna

18 Antenna 4/04/03 Cable Tie 46 cm Reflector, White P.N. 2745282 Dish Bolt(4) P.N. 2160363 LB-6000: STANDARDDUAL LNBF P.N. 2780199 Roller P.N. 2200460 Hex Head Bolt 1/4-20 xx 2.5" P.N. 2160237Nylock Nut 14 - 20 P.N. 2160220 (not shown) Feed Arm P.N. 2744946 Backup Frame P.N. 2744912 Pivot Bracke...

Page 19 - Electronics; Base Assembly

19 SpringP.N. 2160818 Electronics GasketP.N. 2240056 Pivot ShaftP.N. 2590355 Rotate GearP.N. 2200469 HubP.N. 3100736 Worm/Shaft Assem-blyP.N. 2754099 Motor HousingP.N. 3200260 Motor Housing GasketP.N. 2240054 Elevation MotorP.N. 2665041 Screw (3)P.N.2160196 Azimuth MotorP.N. 2665042 Shaft SealP.N. 2...

Page 20 - Turret Assembly

20 Turret Assembly Screw (2) P.N. 2160197Rotate Stop P.N. 3712450Spring P.N. 2160827 Screw P.N. 2160197Rotate Limit SwitchP.N. 2400105 Screw (4) P.N. 2160195Dual Contact (4)P.N. 2162003 Azimuth Switch BracketP.N. 3200261 Screw P.N. 2160197Park Limit Sw. (Wh) P.N. 2400106 Motor Screws(4)P.N. 2160197 ...

Page 21 - Cover installation

21 Cover installation Shroud2200732 Fine ThreadScrew2160090 Coarse ThreadScrew2160091

Page 22 - Troubleshooting the system; UNIT WILL NOT PARK; OFF & SEARCH LEDs are on —

22 Troubleshooting the system This section of your manual will help yousolve occasional problems with your unit. Ifyou cannot solve the problem after using thesuggestions in this section, contact the re-tailer or dealer where you purchased this unit,or call Winegard Technical Support at 1/800/-788-4...

Page 23 - Testing Voltages to Check Electronics

23 Testing Voltages to Check Electronics 1. WHITE 2. PURPLE 3. BLUE 4. GREEN 5. YELLOW 9. BLACK 8. BROWN 6. ORANGE 7. RED CAUTION! Improper alignment of connector plug can cause system failure. USEEXTREME CARE when making connection. Unit MUST BE DISCONNECTEDFROM POWER SOURCE before connecting. Meas...

Page 24 - Warranty

24 Winegard Co. • 3000 Kirkwood St. • Burlington, IA 52601 • 319/754-0600 • Fax 319/754-0787 • www.winegard.com 2452005 Rev. 10/24/05 WINEGARD MOBILE PRODUCTS LIMITED WARRANTY (2 YEARS PARTS; 1 YEAR LABOR) Winegard Company warrants this product against defects in materials or workmanship for a perio...