Transition Networks SPS-48V - Manuals

Transition Networks SPS-48V – Manual in PDF format online.

Manuals:

Manual Transition Networks SPS-48V

1 Page 1
2 Page 2
3 Page 3
4 Page 4

Summary

Page 2 - INSTALLATION; Ensure that external power source is powered OFF.

INSTALLATION NOTE: The TRANSITION Networks 48-to-12 VDC External Power Supply isshipped with four (4) attached feet. 1. For installation, place on any well-ventilated table-top or shelf withaccess to a 48 VDC power source. 2. Connect barrel connector attached to 12 VDC cord on External PowerSupply t...

Page 3 - TECHNICAL SPECIFICATIONS; Input; ±0.5 % of all output within specified range

TECHNICAL SPECIFICATIONS Input Input Voltage 48 VDC Inrush Current 0.20 A (peak cold start) Hold-Up Time 20 msec minimum at full load and nominal inputvoltage Isolation Voltage (Dielectric withstand) Meets IEC 960 for one minute. 1,500 VAC: Output/Input 500 VAC: Input/Safety GND 500 VAC: Output/Safe...

Page 4 - MAINTENANCE; Replacing Power Supply Module Fuse

MAINTENANCE Replacing Power Supply Module Fuse CAUTION: Wear a grounding device and observe electrostatic dischargeprecautions when replacing the fuse in the 48-to-12 VDC External PowerSupply. Failure to observe this caution could result in damage to, andsubsequent failure of, the 48-to-12 VDC Exter...

Transition Networks Manuals