Stanley 2005 Series - Manuals

Page 2 - , turn the keypad back counterclockwise to stop.; perating; Multi-User Electronic Safe Lock

© Copyright 2006, Sargent & Greenleaf Page 2 t o o pen the L ock Make sure the keypad is turned counterclockwise to stop. Press the code digits or letters in order, followed by # . Then, within six seconds, turn the keypad clockwise about 70 degrees, until it comes to a positive stop. Do not put...

Page 3 - This lock is capable of using a; time delay override code; if it; time delay; can be used to open the lock without waiting for; TDO code; only works when your lock uses a time delay.

o penIng the L ock ➥ W Ith n o t Ime d eLay A valid code is needed to open the lock. This is how to open the lock with the original factory master code of 1 2 3 4 5 6. Make sure the keypad is turned counterclockwise to stop.Enter 1 2 3 4 5 6 # Then, within six seconds, turn the keypad clockwise abou...

Page 5 - Time delay

➥ d eLetIng an e xIstIng c ode The holder of the master code (position 0) can delete any other code. The master code cannot be deleted under any circumstances. The holder of the supervisor code (position 1) can delete user codes . The supervisor code cannot be used to delete the master code or itsel...

Page 7 - user code; master code; anagIng; off; anagIng

➥ c anceLLIng u ser d IsabLe In m anagement /e mpLoyee a ccess m ode If you decide user code holders should no longer have the ability to disable the lock, perform the following procedure. 5 6 ✽ master code # ♪♪♪♪♪ 0 # ♪♪♪ 0 # ♪♪♪ User code holders will no longer be able to disable the lock, althoug...

Page 8 - oW

I nformatIon t abLes ➥ d etermInIng y our L ock ’ s m ode of o peratIon Enter 4 3 ✽ The ensuing beep pattern will tell you if your lock is configured in single user, multiple user, or dual control mode. © Copyright 2006, Sargent & Greenleaf Page 8 ➥ Q uIck r eference t abLe BEEP PATTERN 1ST SET ...

Page 9 - Figure 1; attery

Page 9 © Copyright 2006, Sargent & Greenleaf L oW b attery c ondItIon The S&G © X 03 D-Drive ™ lock uses one 9-volt alkaline battery, which is housed in the keypad. We recommend Duracell ® brand. If the battery needs to be replaced, the lock will emit five double-beeps whenever it is opened....

Page 10 - Figure 4; —Carefully slide the battery behind the keypad, into the; Figure 5

Page 10 © Copyright 2006, Sargent & Greenleaf Figure 4 Step 4 —Carefully slide the battery behind the keypad, into the cavity that is designed to hold it (Figure 4). Be sure the battery has dropped all the way to the bottom of the cavity. Step 5 —Gently place any excess wire into the cavity. Mak...

Page 12 - WARRANTY

WARRANTY Seller warrants that for one year from the date of shipment from Seller’s point of manufacture, the goods shall be free from defects in material and workmanship, provided the goods are normally and properly used according to the Seller’s written instructions. THIS WARRANTY IS EXPRESSLY MADE...