Page 4 - Electric Pressure Washer
4 30SS, 36SS, 45SS Rev: 12/21/2011 STANLEY Product Lines Generator Cord Accessories 240V, 10/4, heavy duty extension cords with L14-30 connectors at each end. This cord reduces harmful voltage drops experienced when using most 120V extension cords. Available in 15’ and 25’ lengths and can be combine...
Page 5 - Contents; About the STANLEY Snow Blower Manual
5 30SS, 36SS, 45SS Rev: 12/21/2011 Contents Safety Information and Warnings ......................................................................... 1 Preparation Safety Precautions ............................................................................ 2 Operation Safety Precautions ............
Page 6 - Safety Information and Warnings; Operator must be familiar with all controls, their
1 30SS, 36SS, 45SS Rev: 12/21/2011 Safety Information Emission Control System Information The U.S. and California Clean Air Acts EPA and California regulations require all manufacturers to furnish written instructions describing the operation and maintenance of emission control systems. The followin...
Page 7 - Preparation Safety Precautions; Preparation—Safety Precautions
2 30SS, 36SS, 45SS Rev: 12/21/2011 Preparation Safety Precautions Preparation—Safety Precautions 1. Inspect the area where the equipment is to be used and remove all objects such as rocks, mats, and wire which can be thrown by the machine causing serious injury or death. 2. Disengage all clutches an...
Page 8 - Operation Safety Precautions; Equipment Operation—Safety Precautions
3 30SS, 36SS, 45SS Rev: 12/21/2011 Operation Safety Precautions Equipment Operation—Safety Precautions 1. Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. Carbon monoxide is odorless, tasteless, and can be fatal. 2. Never operate the snow blower withou...
Page 9 - and Technical Assistance call:; GASOLINE IS HIGHLY FLAMMABLE AND; Wait at least 10 seconds to be sure the augers have
4 30SS, 36SS, 45SS Rev: 12/21/2011 Before attempting to use your snow blower, make sure you are familiar with all of the components and have read the manual. Need Help? Parts, Service and Technical Assistance call: 1-919-550-3221 ext. 158 Monday-Friday 8AM-5PM EST [email protected]...
Page 10 - Safety Decals; Safety Decal Identification
5 30SS, 36SS, 45SS Rev: 12/21/2011 Safety Decals Safety Decal Identification The labels shown below are located on your snow blower to warn you of potential hazards and provide you with important safety information. If these decals become difficult to read or are missing from the snow blower, please...
Page 11 - Product Specifications; Models
6 30SS, 36SS, 45SS Rev: 12/21/2011 Product Specifications * Product Specifications may change without notice. Models Feature 30SS 36SS Product Type Snow blower Snow blower Clearing Path 30” 36” Engine 302cc, 11HP 420cc, 15 HP Engine Start 120V Electric Start and recoil 120V Electric Start and Recoil...
Page 12 - Control Panel and Snow Blower Components; Snow Blower Component Identification; Discharge Chute Direction; Control Panel
7 30SS, 36SS, 45SS Rev: 12/21/2011 Control Panel and Snow Blower Components Snow Blower Component Identification (Some components may appear different than shown, depending on the model.) Discharge Chute Discharge Angle Transmission Control Drift Cutters Augers/Impeller Gear box Adjustable Skid Shoe...
Page 13 - Missing Parts Request Form; Please indicate the part that you are missing
8 30SS, 36SS, 45SS Rev: 12/21/2011 Missing Parts Request Form Name Phone Email Address IMPORTANT: Please include your receipt. Without a receipt, your order will be delayed. You may also email us at: [email protected] Fax:1-919-550-3277 If emailing, please scan in your proof of pur...
Page 14 - Assembly Instructions; Step 1: Control Panel Handles; Align the two holes on each side of the control panel; Step 2: Directional Discharge Chute; Fit round spacer onto impeller housing before installing chute.; Need Help With Assembly?
9 30SS, 36SS, 45SS Rev: 12/21/2011 Assembly Instructions Step 1: Control Panel Handles 1. Align the two holes on each side of the control panel handles over the lower handle frame. 2. Insert the bolts through the handlebar holes and frame holes. Secure in place with hardware provided. Insert bolts f...
Page 15 - Chute Rotation Cable Connection (continued)
10 30SS, 36SS, 45SS Rev: 12/21/2011 1. Locate the connection: The chute rotation cable connection is located at the base of the discharge chute between the engine and the discharge 2. Slide the threaded end of the connector down the cable in order to easily see the end of the cable connection. The c...
Page 17 - Step 6: Drive Control; Locate the thin cable on the left side of the snow blower.
12 30SS, 36SS, 45SS Rev: 12/21/2011 Assembly Instructions Step 6: Drive Control 1. Locate the thin cable on the right side (standing from the operator position) of the snow blower. 2. Attach the cable to the threaded end under the drive control handle. The cable extension may need to be attached to ...
Page 18 - Step 11: Filling Oil and Gasoline; Fill the engine with SAE 5W-30 engine oil. Fill the engine; DANGER
13 30SS, 36SS, 45SS Rev: 12/21/2011 Step 9: Skid Shoes 1. Skid shoes are stored in the hardware bag for shipping. 2. Remove from hardware bag, and install skid shoes using the provided fasteners 3. Insert the fasteners so the flat head of the carriage bolt is on the outside of the main housing. CAUT...
Page 19 - Starting the Engine; Starting the Engine Using the Recoil Start
14 30SS, 36SS, 45SS Rev: 12/21/2011 Starting the Engine DANGER: Exhaust contains poisonous carbon monoxide, a colorless and odorless gas. Breathing exhaust can cause loss of consciousness and may lead to death. Do not operate the engine in a confined space where dangerous carbon monoxide fumes can c...
Page 20 - Operating Instructions; Transmission Control; To disengage, let go of the right lever.; Engage Augers/Impeller Control; WARNING
15 30SS, 36SS, 45SS Rev: 12/21/2011 Operating Instructions Transmission Control Your snow blower is equipped with an easily adjustable transmission control, which can be adjusted for forward and reverse speed. There are six forward and two reverse speeds. To change the speed, pull the handle out to ...
Page 21 - Chute Direction Control
16 30SS, 36SS, 45SS Rev: 12/21/2011 Operating Instructions Chute Direction Control To rotate the chute to the right rotate the chute control clockwise. To rotate the chute to the left rotate the chute control counter-clockwise. Headlights To turn on the lights, flip the switch up. To turn off the li...
Page 22 - Using your STANLEY Snow Blower
17 30SS, 36SS, 45SS Rev: 12/21/2011 Operating Instructions Using your STANLEY Snow Blower The following tips will help ensure proper and long lasting use of your STANLEY snow blower. ALWAYS wear proper safety equipment when operating the snow-blower, and make sure you dress appropriately for cold we...
Page 23 - General Maintenance; Do NOT use standard bolts to replace shear bolts.
18 30SS, 36SS, 45SS Rev: 12/21/2011 General Maintenance The Importance of Maintenance Regular maintenance is essential to ensure your snow blower continues to deliver safe and high-quality performance. To help you properly care for your snow blower, the following pages include a recommended maintena...
Page 24 - Maintenance Schedule
19 30SS, 36SS, 45SS Rev: 12/21/2011 Item Procedure Time Interval Break-in (first 5 hrs) Every 8 hrs (daily) Every 40 hrs (weekly) Every 100 hrs (Bi-weekly) Every 200 hrs (monthly) Belts Inspect Tension(adjust if needed) X X Augers/Impeller Inspect X Engine Air Filter Inspect X Engine Oil Check X Cha...
Page 25 - Service Adjustments; Adjusting Drive Cable
20 30SS, 36SS, 45SS Rev: 12/21/2011 Service Adjustments Adjusting Drive Cable If tension seems to be too loose or too tight, the drive cables needs to be readjusted. 1. Loosen the bolt above where the cable screws in to the right side of the control panel. 2. Loosening the bolt enables the cable to ...
Page 26 - Check & Replacing the Augers/Impeller Belt; Remove the screws and simply lift up the cover.
21 30SS, 36SS, 45SS Rev: 12/21/2011 Check & Replacing the Transmission Drive Belt If belt needs to be changed or altered for any reason, the belt is located in the front of the snow blower behind the discharge chute and in front of the wheels. 1. Remove the cover that is protecting the snow blow...
Page 27 - Changing Friction Wheel
22 30SS, 36SS, 45SS Rev: 12/21/2011 Adjusting Discharge Deflector The discharge chute is preset at the factory, but may require adjustment over time or during maintenance. For adjustments, follow the procedure below: 1. Loosen the two nuts at the chute cable mount on the discharge chute. 2. To make ...
Page 28 - Storage Instructions; Short Term Storage
23 30SS, 36SS, 45SS Rev: 12/21/2011 Storage Instructions Short Term Storage x Let engine cool before storing and do not store near flame, high heat, and possible ignitions from sparks. x Always clean off all flammable material as well as grime and dirt before storage. x Wash with mild detergent and ...
Page 29 - Troubleshooting; Problem Possible
24 30SS, 36SS, 45SS Rev: 12/21/2011 Troubleshooting Problem Possible Causes Solution Engine will not start 1. Key in the OFF position 2. Insufficient fuel in the tank 3. Air bubble in the fuel line 4. Fuel valve in OFF position 5. Choke not ON 6. Choke linkage out of adjustment 7. Loose spark plug w...
Page 31 - Replacement Parts
26 30SS, 36SS, 45SS Rev: 12/21/2011 Replacement Parts To order replacement parts, visit our web-site at www.serviceandwarrantyonline.com Or dial Toll Free 1-800-393-0668 Monday-Friday 8AM-5PM OEM Replacement Parts B08911 : Auger/Impeller V-Belts (Belt Spec: MXV4-370) B01110: Transmission (Drive) Bel...
Page 32 - Collector Housing Assembly Reference; Parts Diagram
27 30SS, 36SS, 45SS Rev: 12/21/2011 Collector Housing Assembly Reference Parts Diagram Drawing # Part# Descpription 1 B00610 Discharge Chute Assembly—Black 2 B00810 Discharge Chute Deflector—Black 3 B01010 Drift Cutters—Black (Set of 2) 4 B01410 Auger/Impeller Gearbox 5 B01510 Discharge Chute Rotati...
Page 33 - Chassis Assembly Reference
28 30SS, 36SS, 45SS Rev: 12/21/2011 Drawing # Item # Description Drawing # Part # Description 1 B00110 Snow blower Wheel/Tire Assembly 13 B03511 Chute Direction Control Handle 2 B01110 Transmission Belt (toothed belt) 14 B03811 Discharge Chute Angle Lever 3 B01310 Plastic Belt Guard with Hardware 15...
Page 34 - Limited Warranty & Service; Commercial
29 30SS, 36SS, 45SS Rev: 12/21/2011 Limited Warranty & Service Length of Warranty: *(from the date of original retail purchase) Noncommercial/Nonrental Commercial Rental Engine Manufacturer’s warranty Manufacturer’s warranty Manufacturer’s warranty Transmission Manufacturer’s warranty Manufactur...
