Smeg TRA90P2 - Manuals - manualsarea.com

Page 3 - Risk of damaging the appliance

PRECAUTIONS - 5 91477A378/A e APPLIANCE WHILST IT IS IN USE. • DO NOT MODIFY THIS APPLIANCE. • Always wear personal protective equipment (PPE) before carrying out any work on the appliance (installation, maintenance, positioning or moving). • Do not clean the appliance if it is still hot or in opera...

Page 6 - • This appliance can be used up; For this appliance; • The swing doors are not held in; This user manual

8 - PRECAUTIONS 91477A378/A wires must be 1.5 - 2 Nm. • This appliance can be used up to a maximum altitude of 2,000 metres above sea level. For this appliance • The swing doors are not held in place when open and may tend to close again. During use, pay attention not to come into contact with the i...

Page 7 - DESCRIPTION; General description

DESCRIPTION - 9 91477A378/A e • Keep the inside of the oven clean at all times. Light sources • This appliance contains user-replaceable light sources. • The light sources contained in the appliance are declared suitable for operation at ambient temperature ≥300°C and intended for use in high temper...

Page 9 - Accessories

DESCRIPTION - 11 91477A378/A e steady outflow of air that exits from the rear of the appliance and which may continue for a brief period of time even after the appliance has been turned off. Interior lighting The appliance’s interior lighting comes on:• When the door is opened.• When any function is...

Page 10 - USE; Preliminary operations; Using the accessories; Using the hob

12 - USE 91477A378/A USE Preliminary operations • Remove any protective film from the outside or inside of the appliance, including accessories. • Remove any labels (apart from the technical data plate) from the accessories and shelves. • Remove and wash all the appliance accessories (see chapter &#...

Page 11 - Using the oven

USE - 13 91477A378/A e Wait a few moments and repeat the operation. Keep the knob pressed in longer. Correct positioning of the flame-spreader crowns and burner caps Before lighting the hob burners, make sure that the flame-spreader crowns are correctly positioned in their housings with their respec...

Page 12 - Digital programmer

14 - USE 91477A378/A FAN WITH GRILL FAN ASSISTED CIRCULAIRE BOTTOM HEAT RAPID DEFROST ECO VAPOR CLEAN (on some models only) Digital programmer Minute minder timer button Cooking duration button End of cooking button Value decrease button Value increase button Setting the time On the first use, or af...

Page 16 - CLEANING AND MAINTENANCE; Cleaning the appliance; Cleaning the hob; Knobs

18 - CLEANING AND MAINTENANCE 91477A378/A CLEANING AND MAINTENANCE Cleaning the appliance Cleaning the surfaces To keep the surfaces in good condition, they should be cleaned regularly after use. Let them cool first. Ordinary daily cleaning Always and only use specific products that do not contain a...

Page 18 - Cleaning the oven cavity

20 - CLEANING AND MAINTENANCE 91477A378/A kitchen roll. In case of stubborn dirt, wash with a damp sponge and neutral detergent. 7. When you have finished cleaning, reinsert the intermediate glass pane in its housing in the door. 8. To reposition the internal glass pane, slide the upper part into th...

Page 19 - Extraordinary maintenance

CLEANING AND MAINTENANCE - 21 91477A378/A e were previously removed, separately in warm water and a small amount of detergent. Vapor Clean cycle setting 1. Turn the functions knob to symbol or (where present). 2. Turn the temperature knob to the symbol. 3. Allow the cleaning cycle to run for 18 minu...

Page 20 - INSTALLATION; Gas connection

22 - INSTALLATION 91477A378/A 7. Press the cover completely down so that it attaches perfectly to the bulb support. INSTALLATION Gas connection Carefully screw the connector 3 to the appliance’s gas connector 1 (1/2” thread BSP), placing the supplied seal 2 between them.For Natural Gas connect the a...

Page 22 - Burner and nozzle characteristics tables; Positioning

24 - INSTALLATION 91477A378/A Refit the knob and verify that the burner flame is stable. Turn the knob rapidly from the maximum to the minimum setting: The flame should not go out. Repeat the operation on all gas cocks. Adjusting the minimum setting for LPG Tighten the screw located at the side of t...

Page 26 - Electrical connection; Instructions for the installer

28 - INSTALLATION 91477A378/A 5. Attach the chain and place the appliance against the wall. Mounting the plinth The plinth must always be positioned and secured correctly on the appliance.1. Open the drawer2. Place the plinth in the front bottom part of the appliance. 3. Screw the four side screws t...