Smeg CS9GMWHA2 - Manuals - manualsarea.com

Page 3 - Risk of damaging the appliance

PRECAUTIONS - 5 91477A432/A e THE VICINITY OF THIS APPLIANCE WHILST IT IS IN USE. • DO NOT MODIFY THIS APPLIANCE. • Always wear personal protective equipment (PPE) before carrying out any work on the appliance (installation, maintenance, positioning or moving). • Do not clean the appliance if it is ...

Page 6 - • This appliance can be used up; For this appliance; • The swing doors are not held in; This user manual; To save energy

8 - PRECAUTIONS 91477A432/A screws of the terminal supply wires must be 1.5 - 2 Nm. • This appliance can be used up to a maximum altitude of 2,000 metres above sea level. For this appliance • The swing doors are not held in place when open and may tend to close again. During use, pay attention not t...

Page 7 - DESCRIPTION; General description

DESCRIPTION - 9 91477A432/A e the heat better. • Remove all trays and racks which are not required during cooking. • Stop cooking a few minutes before the time normally used. Cooking will continue for the remaining minutes with the heat which has accumulated inside the oven. • Reduce any opening of ...

Page 9 - Accessories

DESCRIPTION - 11 91477A432/A e Cooling fan The fan cools the oven and comes into operation during cooking. The fan causes a steady outflow of air that exits from the rear of the appliance and which may continue for a brief period of time even after the appliance has been turned off. Interior lightin...

Page 10 - USE; Preliminary operations; Using the accessories; Using the hob

12 - USE 91477A432/A USE Preliminary operations • Remove any protective film from the outside or inside of the appliance, including accessories. • Remove any labels (apart from the technical data plate) from the accessories and shelves. • Remove and wash all the appliance accessories (see chapter &#...

Page 11 - Using the oven

USE - 13 91477A432/A e Wait a few moments and repeat the operation. Keep the knob pressed in longer. Correct positioning of the flame-spreader crowns and burner caps Before lighting the hob burners, make sure that the flame-spreader crowns are correctly positioned in their housings with their respec...

Page 12 - Digital programmer

14 - USE 91477A432/A FAN WITH GRILL FAN ASSISTED CIRCULAIRE BOTTOM HEAT RAPID DEFROST ECO VAPOR CLEAN (on some models only) Digital programmer Decrease key Clock key Increase key Setting the time On the first use, or after a power failure, the digits will be flashing on the appliance’s display.1. Ho...

Page 14 - Cooking advice

16 - USE 91477A432/A 2. Use the increase and decrease keys to set the required minutes. 3. Wait approx. 5 seconds without pressing any key to finish setting the minute minder. The current time and the symbols and appear on the display. A buzzer will sound when the set time is reached.4. Press the de...

Page 15 - Cooking information table

USE - 17 91477A432/A e Advice for defrosting and proving • Place frozen foods without their packaging in a lidless container on the first shelf of the oven. • Avoid overlapping the food.• To defrost meat, use the rack placed on the second level and a tray on the first level. In this way, the liquid ...

Page 16 - CLEANING AND MAINTENANCE; Cleaning the appliance; Cleaning the hob

18 - CLEANING AND MAINTENANCE 91477A432/A CLEANING AND MAINTENANCE Cleaning the appliance Cleaning the surfaces To keep the surfaces in good condition, they should be cleaned regularly after use. Let them cool first. Ordinary daily cleaning Always and only use specific products that do not contain a...

Page 18 - Cleaning the oven cavity

20 - CLEANING AND MAINTENANCE 91477A432/A 4. Then remove the inner glass pane from the front profile. 5. Remove the intermediate glass unit by lifting it upwards. N.B.: in some models, the intermediate glass unit consists of two glasses. 6. Clean the external glass pane and the panes removed previou...

Page 19 - Extraordinary maintenance

CLEANING AND MAINTENANCE - 21 91477A432/A e Removing racks/trays support frames Removing the rack/tray support frames enables the sides to be cleaned more easily.To remove the rack/tray support frames:• Pull the frame towards the inside of the oven cavity to unhook it from its groove A, then slide i...

Page 20 - INSTALLATION

22 - INSTALLATION 91477A432/A Replacing the internal light bulb 1. Completely remove all accessories from inside the oven. 2. Remove the rack/tray support frames.3. Use a tool (e.g. a spoon) to remove the bulb cover. 4. Slide out and remove the light bulb. 5. Replace the light bulb with one of the s...

Page 21 - Gas connection

INSTALLATION - 23 91477A432/A e Gas connection Carefully screw the connector 3 to the appliance’s gas connector 1 (1/2” thread BSP), placing the supplied seal 2 between them.For Natural Gas connect the appliance gas inlet (1 + 2 + 3) to the pressure regulator (4 - not supplied).For Universal LPG con...

Page 23 - Burner and nozzle characteristics tables; Positioning

INSTALLATION - 25 91477A432/A e Burner and nozzle characteristics tables The nozzles not provided are available at Authorised Service Centres. Positioning A: 600 mm (height), measured from the top ofthe highest burner and 750 mm from an exhaustfan. (a mechanical device other than a rangehood for mov...

Page 26 - Electrical connection; Instructions for the installer

28 - INSTALLATION 91477A432/A 2. Attach the chain to the cooker using the screw that was removed in the previous step. 3. Stretch the chain out horizontally so that the other end touches the wall. Mark the position for the hole on the wall. 4. Drill a hole at the marked position and insert a wall pl...