National Instruments NI TB-2708 - Manuals

Page 2 - Caution; What You Need to Get Started; Cautions

NI TB-2708 Installation Guide 2 ni.com The nine SMB connectors on the TB-2708 allow you to easily connect analog input and analog output signals to your National Instruments device. The 14-pin I/O connector located on the bottom of the TB-2708 allows access to digital signals. Caution The TB-2708 is...

Page 3 - not; Installation

© National Instruments Corporation 3 NI TB-2708 Installation Guide Do not substitute parts or modify equipment. Because of the danger of introducing additional hazards, do not install unauthorized parts or modify the device. Return the device to National Instruments for service and repair to ensure ...

Page 4 - DAQ Getting Started Guide; Signal Descriptions

NI TB-2708 Installation Guide 4 ni.com To connect the terminal block to the PXI module I/O connector, refer to Figure 2 as you complete the following steps: 1. Install the PXI module into the chassis and tighten the two module screws. You must install the PXI device before connecting the TB-2708. Re...

Page 5 - S Series User

© National Instruments Corporation 5 NI TB-2708 Installation Guide Figure 4. NI TB-2708 Block Diagram For more detailed descriptions of these signals, refer to the S Series User Manual . Additional signal configuration information is available in Measurement & Automation Explorer (MAX). To acces...

Page 6 - Measuring Floating Signals; resistor in parallel with a 0.1; Measuring Ground-Referenced Signals; S Series User Manual; Configuration; Floating Source

NI TB-2708 Installation Guide 6 ni.com Measuring Floating Signals You can use the TB-2708 to measure floating and ground-referenced analog input signals. To measure floating signal sources, move the switch located under the rubber-sealed door on the enclosure cover for the AI channel you are using t...

Page 7 - Cabling Options; Pin Number; Black

© National Instruments Corporation 7 NI TB-2708 Installation Guide Cabling Options This section describes the cabling options for accessing signals on the TB-2708. A 14-pin connector on the bottom of the TB-2708 provides access to digital I/O signals. Use the MFIT-Pigtail Cable Assembly (part number...

Page 9 - Specifications; Physical

© National Instruments Corporation 9 NI TB-2708 Installation Guide Specifications This section lists the specifications of the TB-2708. These specifications are typical at 25 °C unless otherwise specified. Input/Output Refer to the documentation for your PXI-6115/6120 S Series device to determine th...

Page 10 - Environment; The NI TB-2708 is intended for indoor use only.; Safety; Note; in the Certification column.; Waste Electrical and Electronic Equipment (WEEE); EU Customers; Where to Go for Support; you have access to everything from

NI TB-2708 Installation Guide 10 ni.com Environment The NI TB-2708 is intended for indoor use only. Operating temperature ............................0 to 55 °C Storage temperature ................................–20 to 70 °C Relative humidity ...................................10 to 90% noncondensi...

Page 11 - and follow the calling

© National Instruments Corporation 11 NI TB-2708 Installation Guide National Instruments corporate headquarters is located at 11500 North Mopac Expressway, Austin, Texas, 78759-3504. National Instruments also has offices located around the world to help address your support needs. For telephone supp...