National Instruments NI 78xxR - Manuals

Page 2 - Start»All Programs»; Unpacking; Caution; R Installation; Note; Step 1. Install Application Software and Driver; Caution

Getting Started with R Series Intelligent DAQ 2 ni.com Refer to the LabVIEW Release Notes for installation instructions for LabVIEW and system requirements for the LabVIEW software. Refer to the LabVIEW Upgrade Notes for additional information about upgrading to the most recent version of LabVIEW fo...

Page 3 - Installing an NI PCI-78; Measurement & Automation; icon on the desktop to open Measurement &; Devices and Interfaces; Verify that the device appears under; Devices and Interfaces»RIO Devices

© National Instruments Corporation 3 Getting Started with R Series Intelligent DAQ Figure 2. Installing an NI PCI-78 xx R Device Figure 3. Installing an NI PXI-78 xx R Device in a PXI Chassis 5. For the NI PCI-78 xx R, secure the device mounting bracket to the computer back panel rail. For the NI PX...

Page 4 - Step 3. Connect Signals; R Digital R Series devices.; R Connector Pin Assignments and Locations

Getting Started with R Series Intelligent DAQ 4 ni.com Step 3. Connect Signals Figure 4 shows the I/O connector pin assignments and locations for NI 781 x R Digital R Series devices. Figure 5 shows the I/O connector pin assignments and locations for NI 78 xx R Multifunction R Series devices. Figure ...

Page 6 - Connectivity Options; R Series Connectivity Options; Cable; to the SCB-68 terminal block

Getting Started with R Series Intelligent DAQ 6 ni.com Connectivity Options Accessing the signals on the I/O connectors requires at least one cable and one signal accessory. Table 1 summarizes the National Instruments connectivity options available for use with the NI 78 xx R device. Table 1. R Seri...

Page 7 - Step 4. Using Your NI 78; R Device with a LabVIEW FPGA Example VI

© National Instruments Corporation 7 Getting Started with R Series Intelligent DAQ Step 4. Using Your NI 78 xx R Device with a LabVIEW FPGA Example VI (NI 783 x R/784 x R/785 x R Only) The NI-RIO driver installation includes a variety of example projects to help get you started. This section demonst...

Page 9 - Adding Analog Output to the FPGA Application

© National Instruments Corporation 9 Getting Started with R Series Intelligent DAQ Adding Analog Output to the FPGA Application To expand the LabVIEW FPGA application to include analog output, complete the following steps: 1. On the block diagram of Analog Input (FPGA).vi , insert a new frame betwee...

Page 11 - Where to Go From Here

© National Instruments Corporation 11 Getting Started with R Series Intelligent DAQ 9. On the front panel, locate the numeric control labeled AO Voltage . Right-click the control and select Num Ctrls»Knob from the Express controls palette to change the control type to knob. 10. On the front panel, c...

Page 12 - — Describes the electrical and mechanical aspects of the NI 78; manuals; —Describes the electrical and mechanical aspects of the NI 781; Where to Go for Support; support; outside the United States, contact your local branch office:

National Instruments, NI, ni.com, and LabVIEW are trademarks of National Instruments Corporation. Refer to the Terms of Use section on ni.com/legal for more information about National Instruments trademarks. Other product and company names mentioned herein are trademarks or trade names of their resp...