Jet 414457 - Manuals

7 6.0 Shipping Contents Open carton and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the band saw is assembled and running properly. 6.1 Contents of the Carton 0 1 Band Saw (not shown) 0 1 Belt Guard (A) 0...

8 7.0 Assembly of Stand Tools required for assembly: Two 1/2-inch wrench ( Note: A ratchet wrench may speed assembly time.) 1. Assemble left (A) and right (B) side plates with six 5/16"x3/4" hex cap screws (C 1 ), twelve 5/16” flat washers (D 1 ) and six 5/16" hex nuts (E 1 ). Tighten th...

9 8.0 Assembly of Band Saw Tools required for assembly: – cross point (Phillips) screwdriver – 3mm and 4mm hex wrenches (provided) – 1/2" and 9/16" wrenches Remove any plastic or holding straps from around the band saw. Areas of the machine have been given a protective coating at the factory...

10 8.3 Stock Stop The stock stop is used for making multiple cuts of the same length. 1. Insert the stock stop rod (A, Figure 5) into the hole at the front of the base as shown. Figure 5 2. Secure the rod by tightening the socket set screw (B, Figure 5) with a 3mm hex wrench. 3. The stock stop is mo...

11 The green colored rigid ear, lug or tab, extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box, as shown in Figure 7. Check with a qualified electrician or service personnel if the grounding instructions are not completely understood, or if in d...

12 whenever the stop screw is contacting the socket head cap screw (C, Fig 10). 4. If the vise and blade are square but the pointer (D, Figure 10) is off slightly, loosen the screw and adjust the pointer until it lines up with zero on the scale. Tighten the screw. Note : The handle (A, Figure 10) is...

13 Figure 13 To change the vise to the 60° position: 1. Disconnect band saw from power source. 2. Raise the bow out of the way. Make sure the hydraulic cylinder is closed (valve lever perpendicular to cylinder) so the bow remains stationary. 3. Remove the two socket head cap screws and lock washers ...

15 5. The front bearing (E, Figure 18) is eccentric, and should be adjusted so that it just contacts the blade without pinching the blade or interfering with its movement. Proceed as follows: 6. Loosen the hex nut (F, Figure 18) with a 14mm wrench. 7. Use a 12mm wrench to rotate the small hex nut ju...

16 10.15 Vertical Bow Position 1. The band saw can be placed in vertical position to facilitate blade changes, maintenance, etc. Remove the screw (A, Fig. 22) and slide it out to disengage the hydraulic cylinder (B, Fig. 22). Figure 22 2. Raise the bow all the way. 3. The stop screw (Figure 23) has ...

17 12.0 Maintenance Before doing maintenance on the machine, disconnect it from the electrical supply by pulling out the plug or switching off the main switch. Failure to comply may cause serious injury. Clean the machine of chips, shavings, etc. with a rag or brush. Do not use your hands. If the po...

18 13.0 Troubleshooting Trouble Probable Cause Remedy Motor will not start. No incoming power. Check plug connection. Blown electrical panel fuses. Replace fuses. Defective motor, switch, power cable, or plug. Qualified electrician/service personnel should inspect these items. Band Saw vibrates exce...