Indesit XWA71283WAUS - Manuals

Page 2 - Connecting the electricity and water; Installation; Unpacking and levelling; Unpacking; Levelling

2 AUS Levelling the machine correctly will provide it with stability, help to avoid vibrations and excessive noise and prevent it from shifting while it is operating. If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the washing m...

Page 3 - Technical data

AUS 3 Connecting the drain hose Connect the drain hose, without bending it, to a drain duct or a wall drain situated between 65 and 100 cm from the floor; alternatively, placed it over the edge of a basin, sink or tub, fa- stening the duct sup- plied to the tap ( see figure ). The free end of the ho...

Page 4 - Care and maintenance

4 AUS Care and maintenance Cleaning the pump The washing machine is fitted with a self- cleaning pump which does not require any maintenance. Sometimes, small items (such as coins or buttons) may fall into the protective pre-chamber at the base of the pump. ! Make sure the wash cycle has finished an...

Page 5 - Precautions and tips; General safety

AUS 5 Precautions and tips ! This washing machine was designed and constructed in accordance with international safety regulations. The fol-lowing information is provided for safety reasons and must therefore be read carefully. General safety • This appliance was designed for domestic use only.• Thi...

Page 6 - Description of the washing; Control panel

6 AUS Detergent dispenser drawer: used to dispense detergents and washing additives ( see “Detergents and laundry” ). ON/OFF button: switches the washing machine on and off. PUSH & WASH button : ( see “Wash cycles” ) . WASH CYCLE knob: programmes the wash cycles. Du- ring the wash cycle, the kno...

Page 7 - Indicator lights; Starting a wash cycle

AUS 7 Indicator lights The indicator lights provide important information.This is what they can tell you: Delayed start If the DELAY TIMER function has been activated ( see “Per- sonalisation” ), after the wash cycle has been started the indicator light corresponding to the selected delay period wil...

Page 8 - Wash cycles; Table of wash cycles

8 AUS Wash cycles Table of wash cycles Push & Wash This function allows for starting a wash cycle even when the machine is switched off without having to press the ON/OFF button in advance, or after switching on the machine, without having activated any button and/or selector (otherwise, the Pus...

Page 9 - Setting the temperature; Setting the spin speed; Functions; Personalisation

AUS 9 Setting the temperature Press the TEMPERATURE button to set the wash temperature (see Table of wash cycles ). The temperature may be lowered, or even set to a cold wash . The washing machine will automatically prevent you from selecting a temperature which is higher than the maximum value set ...

Page 10 - Detergents and laundry; Preparing the laundry; Garments requiring special care

10 AUS Detergents and laundry Detergent dispenser drawer Successful washing results also depend on the correct dose of detergent: adding too much detergent will not necessarily result in a more efficient wash, and may in fact cause build up on the in- side of your appliance and contribute to environ...

Page 11 - Troubleshooting

AUS 11 Troubleshooting Your washing machine could fail to work. Before contacting the Technical Assistance Centre ( see “Assistance” ), make sure that the problem cannot be solved easily using the following list. Problem: The washing machine does not switch on. The wash cycle does not start. The was...