Avaya 40DHB0002USCL - Manual

Avaya 40DHB0002USCL

Avaya 40DHB0002USCL – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
Page: / 70

Table of Contents:

  • Page 2 – Contents
  • Page 5 – Introduction; General; appropriate IP Office training courses.; Scope of Manual; Office are covered by the Product Description.
  • Page 6 – Safety and Homologation Statements; CE Mark; accompanying the products.; Lithium Batteries; WARNING; Electromagnetic Interference Information; Federal Communications Commission (FCC); Canada approved the equipment.”; WARNING
  • Page 7 – Trunk Interface Modules; ROW; Interface Modules; be installed in the following IP400 Office products:; Interface; Further Information and Product Updates; This guide is also available from Avaya's support web site:; Support Telephone Numbers; In the USA only; , Avaya provides a toll-tree Customer Helpline 24 hours a day:; Outside the USA; contact your Avaya representative.
  • Page 8 – Regulatory Instructions for Use; IP Office Operation in Australia; kHz Audio; IP Office Operation in Canada
  • Page 9 – IP Office Operation in EU; FCC Notification; Means of Connection
  • Page 10 – IP401 Compact Office Platform; IP401 Compact Office 2 supports:; Two digital and two analog telephones; IP401 Compact Office 4 supports:; Four digital and four analog telephones; WAN Port; Provides memory capacity for embedded voice mail feature.
  • Page 11 – IP401 Compact Office - Front View; Port connections; DT Ports; out; Cascade; in; Cables
  • Page 12 – IP401 Compact Office - Rear View; Port Pinouts and Cables
  • Page 13 – Typical Configuration; Kit List
  • Page 14 – IP403 Office Platform; If Analog 4 modules are used, a second module can be fitted in Slot A.; Expansion Modules; Integral Modules; Dual Modem Module
  • Page 15 – IP403 Office - Front View; LAN Ports
  • Page 16 – IP403 Office - Rear View; These interfaces are
  • Page 18 – IP406 Office Platform
  • Page 19 – IP406 Office - Front View
  • Page 20 – IP406 Office - Rear View; DTE Port; switchable in the installation software to provide 24B trunks.; plugged into the ‘WAN’ port. This cable; must be; connected before power is applied for auto; For Port Pinouts and Cables, refer to pages 51 and 55 respectively.
  • Page 21 – Typical Configurations; interfaces for a Primary rate.; provide the additional 30 lines.
  • Page 22 – IP412 Office Platform
  • Page 23 – IP412 Office - Front View
  • Page 24 – IP412 Office - Rear View; plugged into the WAN port. This cable
  • Page 25 – trunk card in its spare slot to provide the additional 48 lines.
  • Page 27 – -Law PCM encoding. Both DT and DS ports can be set for either; Expansion Port
  • Page 28 – (see page 27) with the exception that the Ports are labeled; DS; not; DT; and support; Pinouts and Cables, refer to pages 51 and 55 respectively.
  • Page 29 – Front View; BRI Ports; BRI phone ports 1-8; must not; be connected to the external ISDN Connections.; Rear View; refer to pages 51 and 55 respectively.
  • Page 30 – The LAN Port is the expansion port and; the cable plugged into the WAN port. This cable; to pages 51 and 55 respectively.
  • Page 32 – Country Variants; that is stuck to the base of each module.; IP400 Office Systems; IP401 Compact Office
  • Page 33 – Integral Module Kits; Trunk Module Kits; BRI Trunk Interface Module; Power Supplies; However, the power leads are county specific and; ordered separately as follows:
  • Page 34 – IP Office Rack Mounting Kits; Rack Mounting Kit; IP400 Digital Terminals
  • Page 35 – Preparing for Installation; This section covers :; Tools & Parts Required; not supplied; Space requirements
  • Page 36 – Environmental requirements; IMPORTANT SAFETY INSTRUCTIONS; Power Supply requirements; IP Office Base Unit and Expansion Modules :
  • Page 37 – Grounding; Protective Ground; Functional Ground
  • Page 38 – Installing a New System; Unpacking; Unpacking and checking :; Initial Assembly; do not
  • Page 39 – Installation of Integral Modules; Procedure; Tx1 GND and or Rx2 GND to Tx2 GND as required.; to a suitable grounding point.
  • Page 42 – Rack Mounting Assembly Instructions
  • Page 43 – IP401 Compact Office Wall Mounting; must not be used
  • Page 44 – IP401 Expansion and Installation of Integral Modules; connected to a suitable grounding point.
  • Page 45 – Basic System Programming; Help; Programming Tools; PC to IP Office LAN Port Connection; LAN Network Connection:
  • Page 46 – Initial Programming; Telephone Installation
  • Page 47 – Checking Telephones; While; Connecting & Testing IP Office Telephones; To check a IP Office telephone :; Connecting & Checking Two-Wire Telephones; To test a power fail socket :
  • Page 48 – Wall Mounting 2000 Series Telephones; movement or vibration.; To wall mount an IP Office telephone :; clearance above and below the telephone is allowed.
  • Page 50 – System Handover; Checklist; Are these been clearly marked and have they been tested?
  • Page 51 – Technical Data; Port Pinouts; standard. Refer to page 55 for cable details.; Description
  • Page 53 – Each circuit can be switched independently.
  • Page 54 – connected to the WAN Ports.
  • Page 55 – Refer to page 51 for port pin out details.; must; conform to all local regulations.; larger telecommunications line cord.; DTE Cable; working voltage of 440V rms and a Maximum current per core of 1A rms; Pin Connections; Name
  • Page 56 – DT Line Cord for Structured Cabling; Line; must only be connected; to the
  • Page 57 – RED; With reference to the TE.
  • Page 58 – LAN Interconnect Cable; GREEN; End A; This cable is used:
  • Page 59 – LAN Cable; GREY
  • Page 60 – LAN Crossover Cable; BLACK; and for connecting a WAN3 to an IP412.
  • Page 61 – Expansion Interconnect Cable; BLUE
  • Page 62 – Connect pin 25 to pin 6 at End A; only; Pin 19 at end A is connected to the Screened Cable Drain Wire.
  • Page 63 – nominal capacitance of 98pF/m, impedance of 77; Connect pin 7 to pin 6 at End A
  • Page 64 – nominal capacitance of 98pF/m, impedance of 80; Connect pins 7 and 25 to pin 6 at End A; This cable is used to connect a WAN port to a Digital leased Line.
  • Page 65 – Telephone Converter Cables; Phone; modules acts as a Master socket, thus only Slave Telephone; RJ45 - Compatible Converter; RJ11 Pin Number; Out of Building Installation; requires the following:
  • Page 66 – Port Safety Classification; Port Name; Compliance with FCC Rules; Transmit and Receive Gain Settings for PRI/T1 and Analog Ports
  • Page 67 – Technical Specifications; Interface Information
  • Page 68 – Protocols; Protocol
  • Page 69 – Index
Loading the manual

IP Office

Installation Manual

40DHB0002USCL – Issue 7 (09/25/2002)

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Contents

Page 2 - Contents Page 2 - Contents IP Office Installation Manual Contents Introduction ......................................................................................................................................................5 General .......................................................

Page 5 - Introduction; General; appropriate IP Office training courses.; Scope of Manual; Office are covered by the Product Description.

Introduction General - Page 5 Introduction General This manual covers the installation of your Avaya IP Office equipped with release Level 1.0+ software. It is intended for use by installers and maintainers who have successfully completed the appropriate IP Office training courses. Ensure that you h...

Page 6 - Safety and Homologation Statements; CE Mark; accompanying the products.; Lithium Batteries; WARNING; Electromagnetic Interference Information; Federal Communications Commission (FCC); Canada approved the equipment.”; WARNING

Page 6 - Lithium Batteries Safety and Homologation Statements Safety and Homologation Statements CE Mark The "CE" mark affixed to this equipment means that the unit complies with the 1999/5/EC (R&TTE), 89/336/EEC (EMC) and 72/23EEC (LVD) Directives Declaration of Conformity The Declarati...

Other Avaya Models

All Avaya Other