Teledyne EHE - Manual

Teledyne EHE

Teledyne EHE – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
Page: / 34

Table of Contents:

  • Page 2 – TABLE OF CONTENTS
  • Page 3 – WARNING; A. General Requirements; Special Precautions
  • Page 4 – B. Heater Assembly and Preparation; Installation at High Elevation; D. Installation Clearances; Table 1. Installation Clearance Requirements.; NOTE: See Outdoor Installation section; E. Outdoor Installation
  • Page 5 – Installation; Figure 3. Vent collar assembly for indoor installation.; G. Indoor Installation
  • Page 6 – Figure 4. Connection of combustion air pipe to heater.; One-Pipe Installation
  • Page 9 – Both combustion air and vent piping joints must; H. Condensate Disposal
  • Page 10 – I. Gas Supply and Piping; Table 4. Gas Supply Pressure Requirements; Table 5. Required Gas Pipe Size
  • Page 11 – When the heater is started, check the supply; High Elevation; To assure good combustion and general
  • Page 13 – Connections
  • Page 15 – IMPORTANT: If an automatic chlorinator is; Figure 22. Pressure Relief Valve Installation.
  • Page 16 – Figure 23. Adjustment of Pressure Switch.
  • Page 18 – With any new pool or spa installation, run the; Caution; B. Temperature Controls; heater has a dual temperature control; IMPORTANT: The temperature controls cannot
  • Page 19 – C. Lighting and Shutdown
  • Page 20 – F. Swimming Pool Energy Savings Tips; NOTE: Teledyne Laars does not warrant heat
  • Page 21 – H. Periodic Inspection
  • Page 23 – C. Heater Components and Their; Temperature Control - The Teledyne Laars
  • Page 25 – Figure 31. Wiring Diagram with Test Points.
  • Page 27 – F. Venturi Combustion Flow System
  • Page 28 – Figure 32. Venturi Flow System Components.
  • Page 29 – If unfired venturi differential or gas orifice; Figure 33. Unfired Venturi Differential Measurement.
  • Page 30 – G. Combustion Condensate; Figure 38. Collector Pressure Measurement
  • Page 32 – To order or purchase parts for the Teledyne
  • Page 33 – Exploded View of the Hi-E2
  • Page 34 – LIMITED WARRANTY; LIMITATION OF LIABILITY:
Loading the manual

FOR YOUR SAFETY - This product must be installed and serviced by authorized person-
nel, qualified in pool/spa heater installation. Improper installation and/or operation can
create carbon monoxide gas and flue gases which can cause serious injury, property
damage, or death. Improper installation and/or operation will void the warranty.

H0205000A

Installation and Operating Data

WARNING

If these instructions are not followed exactly, a fire or explosion may result,
causing property damage, personal injury, or death.

Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas

supplier’s instructions.

• If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service
agency or the gas supplier.

Installation and
Operation Manual

Hi-E

2™

Model EHE
Gas-Fired Pool
and Spa Heater

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - TABLE OF CONTENTS

SECTION 1General Information 1A Introduction ........................................................... 1 1B Description ............................................................ 1 1C Warranty ................................................................ 1 SECTION 2Installation Instructions 2...

Page 3 - WARNING; A. General Requirements; Special Precautions

Hi-E2 Page 1 SECTION 1.General Information 1A. Introduction This manual contains information for the proper installation and operation of the Hi-E 2 Model EHE pool/spa heater. Certain sections are specific to UnitedStates or Canadian installations, and are labeled UnitedStates or Canada. Procedures ...

Page 4 - B. Heater Assembly and Preparation; Installation at High Elevation; D. Installation Clearances; Table 1. Installation Clearance Requirements.; NOTE: See Outdoor Installation section; E. Outdoor Installation

Page 2 2B. Heater Assembly and Preparation The Hi-E 2 can be installed in a variety of ways, some of them requiring preparation or assembly in thefield. In all cases, condensate tubing and fittings,which are provided with the heater, must be connectedand routed. Water connections are provided on the...

Other Teledyne Models

All Teledyne Other