Smeg SHWG910X - User Manual

Page 2 - INDEX; EN

2 2 INDEX RECOMMENDATIONS AND SUGGESTIONS ..................................................................................................................... 3 CHARACTERISTICS .............................................................................................................................

Page 3 - RECOMMENDATIONS AND SUGGESTIONS; INSTALLATION; USE; MAINTENANCE

EN 3 3 RECOMMENDATIONS AND SUGGESTIONS The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. INSTALLATION • The manufacturer will not be held liable for any damages resulting f...

Page 4 - CHARACTERISTICS; Dimensions

EN 4 4 CHARACTERISTICS Dimensions 253 min. 850 max. 1050 740 132 90 433 Min. 500mm Min. 650mm Components Ref. Q.ty Product Components 1 1 Hood Body, complete with: Controls, Light, Blower, Filters 2 1 Telescopic Chimney comprising: 2.1 1 Upper Section 2.2 1 Lower Section 9 1 Reducer Flange ø 150-120...

Page 5 - Wall drilling and bracket fixing

EN 5 5 INSTALLATION Wall drilling and bracket fixing 11 12a 330 X 116 1÷2 116 650 min. 7.2.1 Wall marking: • Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. • Draw a horizontal line at 650 mm above...

Page 6 - Mounting the hood body; Connections; DUCTED VERSION AIR EXHAUST SYSTEM

EN 6 6 Mounting the hood body • Before attaching the hood body, tighten the two screws Vr lo- cated on the hood body mounting points. • Hook the hood body onto the screws 12a . • Fully tighten the support screws 12a . • Adjust the screws Vr to level the hood body. 12a Vr Connections DUCTED VERSION A...

Page 7 - ELECTRICAL CONNECTION; Chimney assembly; Upper exhaust Chimney

EN 7 7 ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch hav- ing a contact gap of at least 3 mm. • Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan...

Page 8 - Control panel

EN 8 8 USE L T1 T2 T3 T4 L1 L2 L3 L4 Control panel Button Function Led L Turns the lighting system on and off. - Press and hold for approx. 2 seconds to turn the lighting system on and off at reduced intensity. - T1 Turn the suction motor on and off at speed one. On. Press and hold the button for ap...

Page 9 - Metal grease filters; Resetting the alarm signal

EN 9 9 MAINTENANCE Metal grease filters These can also be washed in the dishwasher, and need to be cleaned when all the command LEDs light up in a continuous manner or at least once every 2 months use, or more frequently if use is particularly intensive. Resetting the alarm signal • Press button T1 ...

Page 10 - Activating the alarm signal; Lighting; LIGHT REPLACEMENT

EN 1 10 Activated Charcoal Filter (Recirculation Version) • This cannot be washed or regenerated, and must be changed when all the command LEDs start to flash, or at least once every 4 months. Activating the alarm signal • In Recirculation Version Hoods, the Filter Saturation Alarm must be activated...

Smeg SHWG910X - User Manual

Table of Contents:

Summary

Other Smeg Range Hoods Models