Smeg KSM24XU - User Manual - manualsarea.com

Page 2 - EN; INDEX

EN 2 2 INDEX WARNINGS AND REQUIREMENTS .................................................................................................................................... 3 RECOMMENDATIONS AND SUGGESTIONS .................................................................................................

Page 3 - READ AND SAVE THESE INSTRUCTIONS; with a close-fitting; If; You may be burned; VENTING REQUIREMENTS; WARNING - To Reduce The Risk Of Fire, Use Only Metal Ductwork.

EN 3 3 READ AND SAVE THESE INSTRUCTIONS The Installer must leave these instructions with the homeowner. The homeowner must keep these instructions for future reference and for local electrical inspec-tors’ use. READ THESE INSTRUCTIONS BEFORE YOU START INSTALLING THIS RANGEHOOD WARNING: - TO REDUCE T...

Page 4 - W A R N I N G; ELECTRICAL REQUIREMENTS

EN 4 4 W A R N I N G • Venting system MUST lead the air outside the building. • DO NOT expel the air through a ductwork in an attic or other enclosed space. • DO NOT use 4" laundry-type wall caps. • Flexible-type ductwork is NOT recommended. • DO NOT obstruct the flow of combustion and ventilati...

Page 5 - Electrical ground is required on this rangehood.

EN 5 5 WARNING - TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Installation Work And Electrical Wiring Must Be Done By Qualified Person(s) In Accordance With All Applicable Codes And Standards, In-cluding Fire-Rated Construction. Sufficient air is needed ...

Page 6 - RECOMMENDATIONS AND SUGGESTIONS; INSTALLATION

EN 6 6 RECOMMENDATIONS AND SUGGESTIONS The Instructions for Use apply to several versions of this appliance. Accord- ingly, you may find descriptions of individual features that do not apply to your specific appliance. INSTALLATION • The manufacturer will not be held liable for any damages resulting...

Page 7 - DIMENSIONS and MAIN PARTS; Dimensions

EN 7 7 DIMENSIONS and MAIN PARTS Dimensions 5" 1/8 2" 7/16 24'' - 30" - 36" 12" 3" 1/2 12" 1/2 21" 1/4 2" 3/8 10" 5/8 19" 5/16 Min. 35" - Max.38" 1/8 Components Ref. Q.ty Product Components 1 1 Hood Body, complete with: Controls, Light, Blower, Fil...

Page 8 - Wall drilling and bracket fixing

EN 8 8 INSTALLATION Wall drilling and bracket fixing 11 12a 12"5/8 X ÷1/16" 4"9/16 24" 7.2.1 4"9/16 Wall marking: • Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the center of the area in which the hood will be installed. • Draw a hori...

Page 9 - Mounting the hood body; Connections; DUCTED VERSION AIR EXHAUST SYSTEM

EN 9 9 Mounting the hood body • Before attaching the hood body, tighten the two screws Vr lo- cated on the hood body mounting points. • Hook the hood body onto the screws 12a . • Fully tighten support screws 12a . • Adjust screws Vr to level the hood body. Note : The Hood body should be secured to w...

Page 10 - ELECTRICAL CONNECTION; Chimney assembly; Upper exhaust chimney

EN 1 10 ELECTRICAL CONNECTION • Remove the cover from the Field Wiring Compartment with a phillips screwdriver. • Feed the Power Supply Cable through the electrical knockout. Connect the Power Supply Cable to the range- hood cable. At-tach the Power Supply Cable grounding lead to the green screw pro...

Page 11 - USE; Control board

EN 1 11 USE L V1 V2 V3 S Control board L Light Switches the lighting system on and off. S Led Motor running led. V1 Motor Switches the extractor motor on and off at low speed. Used to provide a contin-uos and silent air change in the presence of light cooking vapours. V2 Speed Medium speed, suitable...

Page 12 - CARE; Metal grease filters; REPLACING THE ACTIVATED CHARCOAL FILTER; Lighting; LIGHT REPLACEMENT

EN 1 12 CARE Metal grease filters • The filters must be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a dishwasher. • Remove the filters one at a time, supporting them with one hand and turning the safety knobs (pull and turn). • Wash the ...