Shindaiwa 62891-94311 - Manual

Shindaiwa 62891-94311

Shindaiwa 62891-94311 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
Page: / 68

Table of Contents:

  • Page 2 – A statement preceded by the; Warning labels af fixed to the machine; Contents; The engine exhaust from this
  • Page 3 – Safety Precautions; THE PRUNER IS NOT; Kickback and Pinching
  • Page 4 – The Properly Equipped Operator; Operating Precautions
  • Page 5 – Do not make unauthorized
  • Page 7 – Bar and Chain Options; Assembly; Prior to assembly
  • Page 8 – Adjusting the Throttle Cable
  • Page 9 – Assembling tube sections; Never attempt to install,; Installing and Adjusting the Bar and Chain; Disassembling the tube sections
  • Page 10 – Adjusting the Chain; The saw chain is very sharp.; Chain Oiler; Filling the Oil Reservoir; frequently than at fuel tank refills.; Adjust the pump as follows:
  • Page 12 – Starting the Engine; The cutting blades may move
  • Page 13 – OFF; The cutter attachment can; Stopping the Engine; The cutter attachment must; Check and Adjust Idle Speed
  • Page 14 – Using the Pole Pruner; Preparations
  • Page 15 – General Maintenance; Before performing any mainte-; Ever y 10 hours of operation (more; Prior to each work day, per form the; Daily Maintenance; Operating the engine without; Muffler; Always wear gloves when
  • Page 17 – Long Term Storage; Whenever the unit will not be used; Never operate the unit; Maintenance
  • Page 18 – Sharpening the Chain; Correct Filing Technique
  • Page 19 – ENGINE DOES NOT START; Troubleshooting Guide
  • Page 20 – Additional Problems; Symptom; Engine stops abruptly.
  • Page 21 – Emission System Warranty Statement
  • Page 22 – Notes
  • Page 23 – Manual Del ProPietario / oPeraDor ShinDaiwa; extenSión
  • Page 24 – spañol; Índice; Las emisiones liberadas por
  • Page 25 – Guardarte de apriete.; instrucciones generales de seguridad; ESTE CORTASETOS ARTICU-; Agarre la podadora con firmeza,; Contragolpe y apriete
  • Page 26 – correctamente y que apretado firme; el operario debidamente equipado; Precauciones del funcionamiento; instrucciones de seguridad
  • Page 27 – Nunca modifique ni desactive
  • Page 28 – Especificaciones; iMPortante
  • Page 29 – No haga modificaciones o; Barras y cadenas opcionales; ensamblar; antes de ensamblar
  • Page 30 – ajuste el cable del acelerador
  • Page 31 – instalación la cadena; Las cuchillas de la cadena; Nunca opere esta sierra si no; instalación y ajuste de la barra y la cadena de la sierra; Desmontaje de las secciones del tubo
  • Page 32 – adjuste la cadena; Una cadena floja puede saltar de la; Bomba de aceite; llenado del depósito de aceite; Para garantizar una lubricación sufi; Ajustar la bomba como sigue:
  • Page 33 – Mezcla de combustible; ejemplos de cantidades de; Nunca coloque material inflamable
  • Page 34 – arranque del motor; No jale el arrancador recular hasta; Cuando arranca el motor...; El accesorio de corte se
  • Page 35 – El accesorio de cortes pudo; Parada del motor; El accesorio de corte NUNCA; ajuste de marcha mínima
  • Page 36 – Corte de abundantes ramas finas:; el uso de la potadora de extensión; Preparación
  • Page 37 – Mantenimiento general; Antes de efectuar; Cada 10 horas mantenimiento; Cada 10 horas de operación (más; No opere esta máquina si el filtro; Antes de cada día de trabajo, efectúe; Mantenimiento diario; Silenciador; Usar siempre los guantes al
  • Page 38 – Mantenimiento; Cada 50 horas mantenimiento; Retire y reemplace el elemento del filtro
  • Page 39 – almacenamiento de largo plazo; Cada vez que la máquina no va a ser; Nunca opere la máquina con
  • Page 40 – Luego de haber ajustado todos los; técnica de limado correcta; rendimiento de la cadena
  • Page 41 – Guía de localización de fallas; el Motor no arranca; SÍ
  • Page 42 – otros problemas; Deficiente aceleración.; Qué revisar
  • Page 43 – Declaración de Garantía del Sistema de emisión
  • Page 44 – notas
  • Page 45 – Tronçonneuse à perche; MAnueL D’uTILIsATIon shInDAIWA
  • Page 46 – ançais; Les étiquettes d’avertissement apposées; Introduction; Un énoncé précédé du symbole; Les informations contenues dans le présent; Table des matières; Les échappements du moteur
  • Page 47 – Attention au; consignes de sécurité; L’AppAreIL n’esT pAs IsoLÉ
  • Page 48 – de « ressort » afin de ne pas risquer; consignes d’utilisation; sécurité afin de réduire le risque
  • Page 49 – Ne jamais modifier ni désactiver
  • Page 50 – Caractéristiques techniques
  • Page 51 – Montage de la tête motorisée; Ne pas apporter de modifica; Options du guide-chaîne et de la; Avant l’assemblage; raccord du câble d’accélération
  • Page 52 – Assemblage les éléments du tube; Assemblage
  • Page 53 – Installation de la chaîne; Ne jamais tenter d’installer,; Ne jamais utiliser l’appareil si le; Installation et réglage du guide-chaîne et de la chaîne; Désassemblage des éléments
  • Page 54 – Réglage de la chaîne; La chaîne est très coupante.; Huileur de chaîne; Remplissage du réservoir d’huile; qui nécessite des vérifications plus
  • Page 55 – Mélange de carburant; inflammables avant de le redémarrer.; Remplissage du réservoir de carburant; réduire les propriétés lubrifiantes de
  • Page 56 – Démarrage du moteur; Les lames risquent de tourner
  • Page 57 – Arrêt du moteur; L’accessoire de coupe ne; Vérification et réglage du ré-; L’accessoire de coupe peut
  • Page 58 – utilisation de la tronçonneuse; position de travail
  • Page 59 – Entretien aux 10 heures; Toutes les 10 heures d’utilisation; Ne jamais utiliser l’appareil si le filtre; Appliquer la procédure suivante; Entretien quotidien; à un niveau suffisant pour causer la; Silencieux; entretien; ment immobiles. Débrancher le fil de la
  • Page 60 – Entretien aux 50 heures; Veiller à ne pas percer le conduit; remisage à long terme; Si l’appareil doit être remisé plus de; Avant d’enlever la bougie, nettoyer; Entretien aux 10 à 15 heures; Lubrifier le boîtier réducteur. Pour
  • Page 61 – Entretien du pare-étincelles; Ne jamais faire fonctionner
  • Page 62 – Affûtage de la chaîne; Technique d’affûtage correcte
  • Page 63 – Guide de dépannage; Le moteur ne démarre pas; puIssAnce InsuFFIsAnTe
  • Page 64 – Autres problèmes; Problème; Le moteur s’arrête brusquement.
  • Page 65 – Vos droits et obligations en vertu de la garantie; Déclaration de garantie du dispositif antipollution
Loading the manual

SHINDAIWA OWNER’S/OPERATOR’S MANUAL

P231 POLE PRUNER

Par t Number 62891-94311 Rev. 3/08

Minimize the risk of injury to yourself and others! Read this
manual and familiarize yourself with the contents. Always wear
eye and hearing protection when operating this unit.

WARNING!

English ........... 1

Español .....SP_1

Français ... FR_1

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - A statement preceded by the; Warning labels af fixed to the machine; Contents; The engine exhaust from this

2 Introduction The Shindaiwa P231 Pole Pruner is designed and built to deliver superior performance and reliability without compromise to quality, comfort, safety or durability. Shindaiwa’s high- performance engines represent the leading edge of 2-cycle engine technology, delivering exceptionally hi...

Page 3 - Safety Precautions; THE PRUNER IS NOT; Kickback and Pinching

3 Beware of pinching. Pinching the saw along the tip of the guide bar may force the bar back rapidly toward the operator. Pinching can occur whenever wood closes in around the moving chain. Safety Precautions A pole pruner operates at ver y high speeds and has the potential to do serious damage if m...

Page 4 - The Properly Equipped Operator; Operating Precautions

4 Make sure the chain and sprocket are correctly adjusted before operating the pruner (see page 10 for adjustment procedures). Never attempt chain adjustment with the engine running! Always make sure the cutting attachment is properly installed and firmly tightened before operation. Never use a crac...

Other Shindaiwa Models

All Shindaiwa Other