Page 4 - CHAPTER-7: ELECTRONIC DISPLAY WARNING SYMBOLS 3; CONTENTS
CHAPTER-1: TECHNICAL SPECIFICATIONS 3 CHAPTER-2: BEFORE USING WASHING MACHINE 5 Safety warnings 5 Recommendations 6 CHAPTER-3: SETTING UP ..... 7 Removing transport safety screws 7 Adjusting adjustable stays 9 Electrical connection 10 Water inlet connection 10 Water discharge connection 11 CHAPTER-4...
Page 7 - SAFETY WARNINGS
SAFETY WARNINGS Do not use double adaptors, power boards or extension cords. Do not use if the power cord or plug is damaged. Never pull the cable when unplugging. Do not plug-in or pull out the plug from the receptacle with wet hands to prevent electric shock. Never touch the machine whenwet. Never...
Page 8 - Keep pets away from the washing machine.; RECOMMENDATIONS; compartment of the detergent; As detergent or softener exposed to air for a long time may cause
You must remove the transport screws of your machine before thefirst usage. Faults occurring in a machine operated with thetransport screw fitted shall be out of scope of warranty. Do not put discharging hose of your machine in a vessel or bucket. This appliance is not intended for use by persons (i...
Page 10 - Transport screws shall be removed by pulling out.
Transport screws shall be removed by pulling out. Fit the plastic transport screw taps delivered in accessories bag to theplaces where transport screws have been removed. The transport safety screws should be stored to be used in case of atransportation.Do not operate the machine with the transport ...
Page 12 - Flow of water with pressure of 0.1-1 Mpa will allow your machine to
Electrical connection Your washing machine is set to 220-240V and 50Hz. Water inlet connection Your machine may have either a single inlet (cold) or double waterinlets (cold/hot) based on its specifications. White-capped hoseshould be connected to cold water inlet and red-capped hose tohot water inl...
Page 13 - Water discharge connection; Ensure that water discharge hose is not folded, twisted, crushed or
Water discharge connection Ensure that water discharge hose is not folded, twisted, crushed or elongated. Water discharge hose can be fitted minimum 60 cm and maximum 100 cm above the ground. The end of water discharge hose can be attached to dirty water discharge hole. Never attempt to extend the w...
Page 14 - CHAPTER-4: PRELIMINARY PREPARATION FOR WASHING
Separate your laundries according to their types (cotton, synthetic, sensitive, woollen, etc.), their temperatures (cold, 30°, 40°, 60°,90°) and degree of contamination (slightly stained, stained, highlystained). Never wash your coloured and white laundries together. Wash your coloured laundries sep...
Page 15 - LAUNDRY TYPE
Open the door of your machine. Spread your laundries in your machine. Note: Maximum loading capacity may vary based on thelaundry type you will wash, degree of contamination and theprogramme you have chosen. Do not exceed maximum dryloading capacity indicated in the programme table forwashing progra...
Page 17 - CHAPTER 5: CONTROL PANEL
15 CHAPTER 5: CONTROL PANEL 1- Det er ge nt dr awer 2- Pr ogr am m e k no b 3- El ectr onic dis pl ay a nd a uxi liar y f unc ti on s 1 2 3
Page 21 - CHAPTER 6: OPERATING YOUR MACHINE
Plug your machine in. Turn on the tap. Open the machine door. Load your laundries in your machine. Push the door of your machine until hearing the locking sound to close it. Put detergent and softener in the detergent drawer. Some water may be left in your machine due to quality control testcarried ...
Page 24 - -Spin speed selection and auxiliary function of soaking; when symbol
1-Spin speed selection and auxiliary function of soaking You can set the spin speed for your laundry via spin speed settingbutton. When you select a newprogramme, the maximum spinspeed of the programme you haveselected will be viewed on thedisplay of spin speed. You can gradually reduce the spinspee...
Page 26 - -Washing water temperature selection
2-Washing water temperature selection You can select the washing water temperature with the washing watertemperature adjustment button. Whenever you select a newprogramme, the maximumwashing water temperature isshown on the washing watertemperature display. You can gradually decrease thewashing wate...
Page 27 - machine detects half load, symbol; -Auxiliary function for easy ironing
3-Auxiliary function prewash Very dirty laundry can be pre-washed before the main washwith this function. When using thisfunction, you should put detergentin front washing compartment ofthe detergent drawer. 4-Auxiliary function for rapid wash This auxiliary function will enablethe washing duration ...
Page 28 - -Auxiliary function for delay timer
6-Auxiliary function for delay timer By using this auxiliary function,you can let your machine startwashing after half an hour to 23hours. For time of use electricitycustomer, this allows you to useyour electricity at a cheaper tariffrate. To use auxiliary function of delay timer:- Press time delay ...
Page 29 - In the programmes where this
7-Anti-Allergic auxiliary function In the programmes where this auxiliary function is active, yourmachine will perform an extrarinsing operation on yourlaundries prior to latest rinsingoperation. Note: Anti-Allergic auxiliary function is selected automatically only in Hygiene programme. 27 CHAPTER 6...
Page 31 - Laundry adding to / removing from the machine
Laundry adding to / removing from the machine If you want to add or remove laundries when your machine is running:- Switch your machine to pause mode by pressing on Start/Pausebutton. - After a while, if you see that the symbol has changed on the display, this means that the door of your machine can...
Page 32 - Child lock
Child lock To avoid programme flow from being affected if programme knobs arepressed or programme knob is turned when performing washingoperation in your machine, child lock is available. Child lock will beactivated by pressing on both auxiliary functions of rapid wash andeasy ironing at the same ti...
Page 33 - Cancelling programme
Cancelling programme If you want to cancel any programme running:- Switch the programme knob to 0.- Your machine will stop the washing operation and the programme willbe cancelled.- To get rid of the water accumulated in the machine switch theprogramme knob to any programme.- Your machine will perfo...
Page 34 - Finishing programme; Within 2 minutes after the programme has finished, your
Finishing programme - Your machine will stop by itself as soon as the programme you haveselected finishes.-Expression of “END” will flash on the electronic display. Note: Within 2 minutes after the programme has finished, your machine will extinguish the electronic display to save energy. It will re...
Page 37 - WATER INLET FILTERS
Unplug your machine. Turn the tap off. Filters to avoid dirt and foreign substances in the water frompenetrating into the machine filters are available both on the side ofthe tap and on the ends of water valves along the water inlet hose ofyour machine. If your machine cannot intake sufficient amoun...
Page 39 - As water in the pump may be hot, wait until it cools down.
After cleaning the filter, fit the filter cover by rotating it clockwise. Fit the pump section of the toe board. Remember that water will leak if you do not fit the filter cover properly. You can use the pump section of the toe board for discharging slight amount of water remaining in the pump of yo...
Page 40 - Do not wash your detergent drawer in dishwasher.
Your detergents may deposit residue in the detergent drawer andhousing of detergent drawer over time. To clean the residue formed,disassemble the detergent drawer in particular periods. To eject thedetergent drawer: Pull the detergent drawer up to the end Keep on pulling by depressing on the flush c...
Page 42 - Grease and oil stains:
Alcoholic drinks: Spotted areas should initially be washed using cold water, and then be wiped with glycerine andwater and rinsed with vinegar-mixed water. Shoe shine: Spots should be rubbed out gently without damaging the cloth and be scrubbed and rinsed withdetergent. If not removed, it should be ...
Page 52 - DISPOSAL OF YOUR OLD MACHINE
This symbol on the product or package implies that theproduct should not be treated as domestic waste.Instead, it should be delivered to applicable wastecollection places recycling electrical and electronicequipment. You will contribute to avoid potential negative results regarding environment and h...