Ridgid R350PNA - Manual

6 GLOSSARY OF TERMS Activate (operating controls) To move an operating control so that it is in a position that allows the tool to be actuated or that satisfies one require-ment for the tool to be actuated. Actuate (tool) To cause movement of the tool component(s) intended to drive a fastener. Actua...

7 FEATURES Fig. PRODUCT SPECIFICATIONS Operating Pressure.................................................................................................................................................50-0 psiAir Inlet ...................................................................................

8 UNPACKING This product has been shipped completely assembled.  Carefully remove the tool and any accessories from the box. Make sure that all items listed in the packing list are included.  Inspect the tool carefully to make sure no breakage or damage occurred during shipping.  Do not discard t...

9 OPERATION Fig. PREPARING THE TOOL FOR USE See Figure 2. Under normal use conditions, the tool should be lubricated before connecting the tool to an air supply. Add air tool lu-bricant into the air fitting on the tool once daily with minimal use, or twice a day with heavy use. Only a few drops of o...

0 Fig. 4 AIR HOSE CONNECTOR SWIVEL CONNECTOR Fig. 3 LOADING THE TOOL WITH NAILS See Figures 3 - 4. WARNING: The tool’s driving mechanism may cycle when the tool is first connected to the air supply. Always connect the tool to the air supply before loading nails to prevent injury from unintended cycl...

LEFT HAND LATCH OPERATION DRIVE DEPTH ADJUSTMENT TO INCREASE DEPTH TO DECREASE DEPTH Fig. 7 HOOK-AND-LOOP AND LOOP TOP RIGHT HAND LATCH Fig. 5 Fig. 6 DRIVE DEPTH ADJUSTMENT See Figure 5. The driving depth of the nail may be adjusted. It is advisable to test the depth on a scrap workpiece to determin...

MAINTENANCE LUBRICATION Frequent, but not excessive, lubrication is required for best performance. Oil added through the air line connection will lubricate the internal parts. Do not use detergent oil or additives as these lubricants will cause accelerated wear to the seals and bumpers in the tool,...

3 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Tool does nothing or operates sluggishly Tool jams frequently Inadequate air supplyInadequate lubricationWorn or damaged O-rings or bumper Verify adequate air supplyLubricate toolInstall Overhaul Kit and replace O-rings Incorrect fastenersDamaged fas...

4 WARRANTY Proof of purchase must be presented when requesting warranty service. This product is manufactured by One World Technologies, Inc. The trademark is licensed from RIDGID, Inc. All warranty communications should be directed to One World Technolo-gies, Inc., attn: RIDGID Pneumatic Tool Techn...

6 987000-09 08-0-07 (REV:0) Customer Service Information: For parts or service, contact your nearest RIDGID ® authorized service center. Be sure to provide all relevant information when you call or visit. For the location of the authorized service center nearest you, please call -866-539-70 or visit...