Ridgid AC9944 - Manual

7  Pull up on lock mechanism release lever and carefully raise wheel legs.  Continue to raise wheel leg set until locked into position. UNPACKING This product requires assembly.  Carefully remove the product and any accessories from the box. Make sure that all items listed in the packing list are...

8 Fig. 6 ASSEMBLY SECURING THE LIFT ASSIST HANDLE See Figures 5 - 6.  Insert hex bolt into hole on each side of handle but do not insert through stand table.  Insert plastic washer between handle and stand table onto the bolt. Push bolt through the hole in the stand table.  Place a washer and loc...

9 Fig. 10 ASSEMBLY ATTACHING THE TRANSPORT HANDLE See Figure 8.  Align transport handle ends with holes in stand table end caps and insert.  Place a spring washer over the screw and insert screw through each hole of the handle and leg support bracket.  Place a washer and lock nut over the end of ...

12 �To remove saw from workstand:  Push locking lever release buttons and raise the locking levers to unlock the saw mounting brackets assembly. ��  Grasp the handles on either side of the assembly and lift away from the rear edge of the table to disengage.  �With the assembly tilted slightly tow...

13 DOBLEZ ABAJO FOLD DOWN SETUP SUJETE Y SOSTENGA EL MANGO DE APOYO FIRMEMENTE Y EN FORMA SEGURA AL DESPLEGAR O PLEGAR EL BANCO SERREZ BIEN ET TENEZ FERMEMENT LA POIGNÉE AUXILIAIRE QUAND VOUS OUVREZ OU PLIEZ LE SUPPORT INSTALE INSTALLATION PLI VERS LE BAS SECURELY GRIP AND HOLD ASSIST HANDLE FIRMLY ...

14 OPERATION WARNING: Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. WARNING: Always wear safety goggles or safety glasses with side shields when operating products. Failure to do so could result in o...

15 15 20 25 30 35 40 45 10 USING THE WORK SUPPORT See Figure 20. Rest the workpiece on top of the work support to support the workpiece during cutting operations. NOTE: More than one work support can be used on an extension arm at a time when extra support is necessary. Always lower extension arm su...

16 MAINTENANCE WARNING: When servicing use only identical RIDGID replacement parts. Use of any other parts may create a hazard or cause product damage. WARNING: Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, als...

17 MAINTENANCE Fig. 23 WARNING: The saw mounting brackets are designed to fit snugly over the table edges with locking levers in the open position. With the locking levers in the lowered (locked) position, you should not be able to slide the saw mounting bracket assembly along the table edges or rem...

19 WARRANTY Proof of purchase must be presented when requesting warranty service. Limited to RIDGID ® hand held and stationary power tools purchased 2/1/04 and after. This product is manufactured by One World Technologies, Inc. The trademark is licensed from RIDGID, Inc. All warranty communications ...

20 Customer Service Information: For parts or service, contact your nearest RIDGID authorized service center. Be sure to provide all relevant information when you call or visit. For the location of the authorized service center nearest you, please call 1-866-539-1710 or visit us online at www.ridgid...