Ridgid 2048-OS - Manual
Ridgid 2048-OS – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – PADLOCK INSTALLATION INSTRUCTIONS FOR ALL UNITS; FOR FIELD DESK CAPABILITY; NOT; WARNING
- Page 3 – SIDE VIEW; TOOLS REQUIRED- Hammer and flat blade screwdriver.
- Page 4 – FOR REPLACEMENT PARTS, CONTACT RIDGID ON-SITE STORAGE EQUIPMENT; • Casters are not suitable for keeping the units in place; CAUTION; RIDGID is a registered trademark of RIDGID, Inc. and is used; • No other replacement parts are available for these models.; ” Caster Set
For Models 2048-OS and 204830-OS:
• Do
NOT
put fuels, flammables, explosives or hazardous
materials inside these products.
• Gasoline, solvents, gun powder or other munitions,
dynamite, propane, acetylene or other such products
can explode if stored inside these products.
• Use these products
ONLY
for storing and transporting
electric or hand tools and equipment, and other similar
materials.
• Failure to follow these warnings or modifications or
other uses of these products could result in death, seri-
ous injury or property damage.
OPERATORS MANUAL
MODELS 2032-OS, 2048-OS, 204830-OS, 3068-OS
RIDGID ON-SITE STORAGE EQUIPMENT
DANGER
–NOTICE–
Keep hands clear when closing lid. Failure to do so could result in severe injury.
WARNING
Read and understand all instructions and warnings before operating or using this product.
–ATTENTION–
To prevent electric shock, explosion, fire and/or serious
personal injury when using storage chest with:
Extension Cord -
• Follow all Extension Cord manufacturer’s Warnings and
Instructions.
• After removing knock-out, insert Rapid Pass™ rubber
grommet. Do
NOT
insert extension cord through hole
without grommet in place (see figure 8, on page 3).
• Only use a three-wire extension cord with all three prongs
intact. Never remove the round grounding prong.
• Extension cord must be connected to a 120 Volt GFCI
protected outlet with proper ground. If GFCI outlet is not
available, use an extension cord with GFCI protection
built in.
• Check the insulation and plugs of extension cord before
using. Do
NOT
use cord if it is worn or damaged.
• Do
NOT
overload extension cord.
• Remove extension cord from the Rapid Pass™ hole
before moving or transporting storage chest.
• Only use an extension cord that is rated for outdoor
use.
• Do
NOT
connect extension cord to outlet that also sup-
plies critical safety equipment with power.
Cordless Power Tool Battery Chargers -
• See Charger’s Owner’s Manual for proper use and care
of charger and batteries. Follow all Warnings and
Instructions provided with your battery charger.
• Place chargers and electrical connections in tray.
• Chargers are Dry location use only. Do
NOT
expose to
liquid, vapor, or rain. Should your charger become wet,
Do
NOT
attempt to use. Unplug extension cord from
supply before handling wet charger or cords.
• Only use chargers and batteries that are intact and oper-
ating properly.
• Do
NOT
touch metal prongs when plugging charger into
extension cord.
• Keep flammable materials like paper or rags away from
charger, cords or connections.
• Do
NOT
place or attempt to charge lead acid, car type
batteries in storage chest.
WARNING
Any modification or unintended use of this product
shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or
property resulting from any modification to, or unintended
use of this product.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
PADLOCK INSTALLATION INSTRUCTIONS FOR ALL UNITS TOOLS REQUIRED- One wrench with 7/16” socket.PADLOCK INFORMATION- Padlock with 7/8”–1” shackle height (figure 3) (recommended Master No 5 or equiva-lent, not included). 1. Open your padlock and slide the U-bolt over the lock shackle. 2. Slide the lock ...
ADJUSTING THE FLEXI-SHELF™ FOR YOUR STORAGE NEEDS FOR REMOVING THE SHELF FROM BOX 2048-OS AND 204830-OS FLEXI-SHELF™ INSTRUCTIONS 1. Be sure all contents are removed from shelf. 2. Securely grasp shelf at the right side (fac- ing box) with both hands and gently lift (figure 7). 3. Remove from box an...
FOR REPLACEMENT PARTS, CONTACT RIDGID ON-SITE STORAGE EQUIPMENT AT 1-800-4-RIDGID (1-800-474-3443) • Casters come as a set of four.• Load ratings are for all four wheels combined.• Load rating includes storage chest weight and contents. • Casters are not suitable for keeping the units in place when ...