ResMed AutoSet CS - Manual

English 3 Getting started 1. Make sure the power is connected.2. Adjust the ramp time if required.3. Fit your mask as described in your mask user guide.4. To start therapy, simply breathe into the mask and/or press . 5. Lie down and arrange the air tubing so that it is free to move if you turn in yo...

English 4 Troubleshooting If there is a problem, try the following suggestions. If the problem cannot be solved, contact your equipment supplier or ResMed. Do not attempt to open these devices. Problem/Possible cause Solution No display Power is not connected. Ensure the power cable is connected and...

English 5 Device does not stop when you remove your mask SmartStart/Stop is disabled. Note: SmartStart/Stop is not available if Leak Alert is enabled. Enable SmartStart/Stop. SmartStart/Stop is enabled but the device does not stop automatically when you remove your mask Incompatible mask system bein...

English 6 Displays error message: Check ResMed 30/90W Power Supply Unit and fully insert the connector The DC plug is partially inserted into the back of the device or inserted too slowly. Fully insert the DC plug. A non-ResMed power supply unit is connected to the device. Remove the power supply un...

English 7 SD card An SD card has been supplied to gather therapy data from your device and provide settings updates from your clinician. When instructed to do so, disconnect the device from the power outlet, remove your SD card, insert it in the protective folder and send it to your clinician. For m...

English 8 Operating temperature +5ºC to +35ºC Note: The air flow for breathing produced by this therapy device can be higher than the temperature of the room. Under extreme ambient temperature conditions (40ºC) the device remains safe. Operating humidity 10–95% non-condensing Operating altitude Sea ...

English 9 Notes: • The manufacturer reserves the right to change these specifications without notice. • The temperature and relative humidity settings displayed for Climate Control are not measured values. • Check with your clinician/service provider before using the SlimLine or ClimateLine air tubi...

English 10 Environmental information WEEE 2002/96/EC is a European Directive that requires the proper disposal of electrical and electronic equipment. These devices should be disposed of separately, not as unsorted municipal waste. To dispose of your device, you should use appropriate collection, re...

English 12 WARNINGS • Read the entire manual before using the device. • Use the device only as directed by your physician or healthcare provider. • Use the device only for the intended use as described in this manual. Advice contained in this manual should not supersede instructions given by the pre...

English 13 • Do not use electrically conductive or antistatic air tubings. • Do not use the air tubing if there are any visible signs of damage. • Only ResMed air tubing and accessories should be used with the device. A different type of air tubing or accessory may alter the pressure you actually re...