Pelco TLR3168 - Manual

Pelco TLR3168

Pelco TLR3168 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
75 Page 75
76 Page 76
Page: / 76

Table of Contents:

  • Page 2 – CONTENTS; Section
  • Page 4 – LIST OF ILLUSTRATIONS; Figure; LIST OF TABLES; Table
  • Page 5 – WARNING; AVERTISSEMENT; CET APPAREIL À LA PLUIE NI À L’HUMIDITÉ.; GENERAL
  • Page 6 – The included
  • Page 9 – TLR3168 FEATURES AND FUNCTIONS; The battery backup
  • Page 10 – QUICK START; BASIC START; This section is
  • Page 11 – INSTALLATION; PRE-INSTALLATION CAUTIONS; If you need to record multiple cameras, a multiplexer is required.; SECURING THE VCR CONTROLS; Pelco recommends using a CCTV monitor.
  • Page 12 – Remove the VCR and all cables from the box.; Figure 1. Typical System Setup
  • Page 13 – CONNECTING THE VCR TO A MULTIPLEXER; Cameras and; Figure 2. Connecting a VCR to a Multiplexer; Figure 2 shows how to connect the VCR to an MX4000 Series Genex
  • Page 14 – ALARM RECORDING CONNECTION; Figure 3. Alarm Recording Connection; CONNECTING FOR SERIES RECORDING; Figure 4. Connecting VCRs for Series Recording; CONNECTING FOR REMOTE RECORDING; Figure 5. Connecting for Remote Recording; Connect the VCR with a remote switch as shown in Figure 5.
  • Page 15 – CONNECTING FOR SYNCHRONOUS RECORDING; Figure 6. Connecting for Synchronous Recording; CONNECTING FOR EXTERNAL TIME CLOCK ADJUSTMENT; Figure 7. Connecting for External Time Clock Adjustment
  • Page 16 – CONNECTING THE VCR TO A PC; Figure 8. VCR to PC Connection; CONNECTING TO A PC FOR REMOTE CONTROL
  • Page 17 – Cable Connections; FRAME
  • Page 18 – CONTROLS; FRONT PANEL; Figure 9. Front Panel
  • Page 20 – FLUORESCENT DISPLAY; Figure 10. Fluorescent Display; Lights during counter memory stop.
  • Page 22 – REAR PANEL; Figure 11. Rear Panel; Input Terminals
  • Page 23 – JOG AND SHUTTLE CONTROLS; Figure 12. JOG Dial and SHUTTLE Ring; USING THE JOG DIAL; Turn by using your finger on the indent.; USING THE SHUTTLE RING
  • Page 24 – ADJUSTING THE CLOCK; Turn the SHUTTLE ring right. The VCR’s clock is now set.; ADJUSTING TO THE EXACT SECOND
  • Page 25 – PROGRAMMING; GENERAL PROGRAMMING INSTRUCTIONS; Menu
  • Page 26 – QUICK GUIDE TO THE MENU STRUCTURE; Figure 14. Menu Tree
  • Page 27 – MAIN MENU; Figure 15. Main Menu; DISPLAY MENU; Figure 16. Display Menu; alarm recording counter.; SMALL; The letters become small.; LARGE; The letters become large.; BLUE BACK; This is where you set the background color.; ON; The recorded picture is overlaid with the menu display.
  • Page 28 – TIMER PROGRAM; Figure 17. Timer Program Illustration; Timer Recording section for more detailed information; DW
  • Page 29 – RECORDING SET UP MENU; Figure 18. Recording Set; Up Menu; Refer to the
  • Page 30 – REAR TERMINAL MENU; Figure 19. Rear Terminal
  • Page 31 – MODE OUT; REC – During recording; REC IN; Sets the REC IN terminal’s operating mode.
  • Page 32 – To stop the buzzer,; Figure 20. First Time Set; TIME DATE ADJUST
  • Page 33 – TRANSMISSION RATE; ADDITIONAL MATERIAL; Alarm recording counter
  • Page 34 – SET THE DAY AND TIME; If power goes out
  • Page 35 – LOADING, UNLOADING, PROTECTING THE TAPE CASSETTE; LOADING; CORRECT
  • Page 36 – Table C. Tape Replacement by Use
  • Page 37 – RECORDING; MANUAL RECORDING
  • Page 38 – RECORDING MODE; Recording Mode; RECORDING CHECK FUNCTION; Press the MENU button. The Main menu appears.
  • Page 39 – Table E. Action When Tape End Is Reached by Setting; STOP; REPEAT; Same as above; ALARM•PROT; Recommended Number of Tape Uses; SERIES RECORDING; Series Recording 2
  • Page 40 – REMOTE RECORDING
  • Page 41 – SYNCHRONOUS RECORDING; Figure 22. Synchronous Recording Sequence; Recording Time Mode; The programming procedure is as follows
  • Page 44 – ALARM RECORDING; When an alarm occurs, the VCR switches to alarm recording.; Table G. Minimum Interval Between Recordings; Alarm Recording; An alarm recording is cancelled if the tape reaches its end.; Figure 23. VCR Switches to Alarm Mode; Alarm signal input; Recording
  • Page 45 – PROGRAMMING FOR ALARM RECORDING; Alarm recording stops when the end of the tape is reached.; If an alarm input is
  • Page 46 – RECORDING AFTER A POWER FAILURE; MAINTENANCE; POWER LOSS LIST; Figure 24. Maintenance; VIEWING THE POWER LOSS LIST; CLEARING THE POWER LOSS LIST
  • Page 48 – ELAPSED TIME AND REPEAT RECORDING TIMES DISPLAY; ELAPSED TIME; The number of tape uses is reset when a new tape is inserted.
  • Page 49 – PLAYBACK; PLAYBACK PROCEDURE; Figure 25. Playback Controls; Turn the JOG dial to select ON, and then turn the SHUTTLE ring right.
  • Page 50 – Table H. Audio Playback and Picture Quality; END OF TAPE; Table I. End of Tape Actions; SPECIAL EFFECTS PLAYBACK
  • Page 51 – Figure 26. Shuttle Ring Speed Settings; DIRECT SHUTTLE RING; Figure 27. Direct Shuttle Ring Speed Settings
  • Page 52 – Figure 29. Picture Quality Adjustment; To adjust during playback:; ADJUSTING PICTURE QUALITY; IF NOISE APPEARS
  • Page 54 – SEARCH TECHNIQUES; COUNTER MEMORY STOP; Figure 31. Skip Search
  • Page 55 – INDEX SEARCH; To exit the Search Function menu without searching, press STOP.; HOW TO COUNT THE INDEX NUMBER; The maximum count of alarm recordings is; Figure 32. Index Searching
  • Page 56 – TIME AND DATE SEARCH; You can find a picture recorded at a specific date and time.
  • Page 57 – ADDITIONAL FUNCTIONS AND FEATURES; The backup is for
  • Page 58 – USING WITH A PC; ASSIGNING THE RS-S32C SETTINGS
  • Page 59 – Figure 33. Commands When Controlling One VCR; Example 1
  • Page 60 – WHEN CONTROLLING MULTIPLE VCRS; Figure 34. Commands When Controlling Multiple VCRs; Sending Commands
  • Page 61 – Example 2; Command for recording
  • Page 62 – COMMANDS AND RESPONSES CHART; The chart uses the following conventions:; Commands
  • Page 67 – out
  • Page 68 – ERROR CODES; Error; TESTING; INITIAL SYSTEM TESTING
  • Page 69 – TROUBLESHOOTING; SELF-DIAGNOSTIC FUNCTION AND WARNING DISPLAY; Table J. Warning Display and Actions
  • Page 70 – BEFORE CALLING FOR SERVICE; SYMPTOM
  • Page 72 – SPECIFICATIONS; ELECTRICAL
  • Page 73 – Table K. Tape Speed and Recording Time
  • Page 74 – INDEX; JOG dial operation 23
  • Page 76 – REVISION HISTORY; REGULATORY NOTICES; Reorient or relocate the receiving antenna.
Loading the manual

TLR3168

Time-Lapse VCR

Installation/

Operation Manual

C673M (2/01)

Pelco • 3500 Pelco Way • Clovis, CA 93612-5699 USA • www.pelco.com

In North America and Canada: Tel (800) 289-9100 or FAX (800) 289-9150

International Customers: Tel +1 (559) 292-1981 or FAX +1 (559) 348-1120

®

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - CONTENTS; Section

2 Pelco Manual C673M (2/01) CONTENTS Section Page GENERAL .......................................................................................................................... 5 SAFEGUARDS, WARNINGS, CAUTIONS, AND CARE ............................................ 6UNPACKING INSTRUCTIONS ..........

Page 4 - LIST OF ILLUSTRATIONS; Figure; LIST OF TABLES; Table

4 Pelco Manual C673M (2/01) LIST OF ILLUSTRATIONS Figure Page 1 Typical System Setup ....................................................................................... 12 2 Connecting a VCR to a Multiplexer ................................................................... 13 3 Alarm Recording...

Page 5 - WARNING; AVERTISSEMENT; CET APPAREIL À LA PLUIE NI À L’HUMIDITÉ.; GENERAL

Pelco Manual C673M (2/01) 5 RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol,within an equilateral triangle...

Other Pelco Models

All Pelco Other