Pelco CC3700H-2 - Manual - manualsarea.com

Page 3 - CONTENTS; LIST OF ILLUSTRATIONS

Pelco Manual C1986M-B (11/03) [ 3 ] CONTENTS IMPORTANT SAFEGUARDS AND WARNINGS ..................................................................................................... 4Regulatory Notices ......................................................................................................

Page 4 - IMPORTANT SAFEGUARDS AND WARNINGS; shall be placed on the apparatus.; AID/AIV Lens Connector; The product and/or manual may bear the following marks:

[ 4 ] Pelco Manual C1986M-B (11/03) IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should be observed. 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near ...

Page 5 - DESCRIPTION; Models; Reorient or relocate the receiving antenna.

Pelco Manual C1986M-B (11/03) [ 5 ] DESCRIPTION The CC3700 Series is a compact, color video camera with a 1/3-inch CCD imager. All cameras have a directdrive/auto iris lens connector and adjustable back focus, and they accept C and CS lenses. Models CC3700S-2 Standard resolution, 330 TV lines, Super...

Page 6 - CAMERA LAYOUT; also hides the power connectors and protects the DIP switches.; INSTALLATION; Lens Mounting; Back

[ 6 ] Pelco Manual C1986M-B (11/03) CAMERA LAYOUT NOTE: The cosmetic trim ring conceals the LED light for more discreet surveillance operations. The trim ring also hides the power connectors and protects the DIP switches. Figure 1. Camera Layout INSTALLATION Lens Mounting The CC3700 Series camera ca...

Page 7 - PIN; Camera Mounting

Pelco Manual C1986M-B (11/03) [ 7 ] PIN DC (AID) AUTO IRIS LENS VIDEO (AIV) AUTO IRIS LENS 1 Control coil negative (-) Lens positive supply 2 Control coil positive (+) Not used 3 Drive coil positive (+) Video drive signal 4 Drive coil negative (-) Ground Figure 2. AID/AIV Lens Connector Camera Mount...

Page 8 - POWER AND VIDEO CONNECTIONS; Power Supply Connections

[ 8 ] Pelco Manual C1986M-B (11/03) POWER AND VIDEO CONNECTIONS The CC3700 Series camera is designed to operate from a 12 VDC or 24 VAC power supply. The power supplyconnections are shown in Figure 4. The LED on the back panel of the camera indicates that power is connected.Use only a UL Listed Clas...

Page 9 - AC Operation Only; Recommended Wire Gauge and Wiring Distances; Wire Gauge; a minimum wire gauge of 20 AWG.; Maximum Distance; All-copper braided shield with 95% braid coverage

Pelco Manual C1986M-B (11/03) [ 9 ] AC Operation Only – If you are wiring more than one camera to the same transformer, connect one side of the transformer to the same terminal on all cameras, and connect the other side of the transformer to the remainingterminal on all cameras. Failure to connect a...

Page 10 - LENS SETUP AND FOCUS PROCEDURES; Video Drive Auto Iris Lens; ESC

[ 10 ] Pelco Manual C1986M-B (11/03) LENS SETUP AND FOCUS PROCEDURES Video Drive Auto Iris Lens When a video drive auto iris lens is used, the lens mode selector switch must be set to AIV. Switch the ESC andAGC OFF. Refer to the lens instructions and adjust the lens for the optimum picture (video ou...

Page 11 - BACK FOCUS ADJUSTMENT; To adjust the back focus:

Pelco Manual C1986M-B (11/03) [ 11 ] BACK FOCUS ADJUSTMENT The back focus adjustment is located at the front of the camera and is accessible from either side of the case. To adjust the back focus: 1. Loosen the two back focus locking screws (one on each side). 2. Turn the back focus ring: a. Clockwi...

Page 12 - SWITCH SETTINGS; NOR

[ 12 ] Pelco Manual C1986M-B (11/03) SWITCH SETTINGS Figure 7. Switch Settings (Defaults) Gamma (NOR/LIN Switch) - Switch Setting 8 Sets the Gamma level to one of the following: NOR (Default setting) - Increases visibility in dark areas of the picture. LIN - Linear response increases (overall) contr...

Page 13 - Shutter Speed Selection -; Flickerless; OFF

Pelco Manual C1986M-B (11/03) [ 13 ] Shutter Speed Selection - Switch Settings 4, 3, 2, and 1 ESC (Electronic Sensitivity Control) Switch Settings 4, 3, and 1 The ESC feature compensates for an excessive light level by automatically adjust-ing shutter speed. Following are the ESC switch settings: ES...

Page 14 - CAMERA SYNCHRONIZATION; To synchronize the cameras do the following:

[ 14 ] Pelco Manual C1986M-B (11/03) CAMERA SYNCHRONIZATION When using more than one camera power supply, a brief vertical roll may occur on the monitor when a cameraview is switched. To eliminate vertical roll, adjust the phase control by synchronizing, or line-locking, the camerasto one another. S...

Page 15 - SPECIFICATIONS; GENERAL

Pelco Manual C1986M-B (11/03) [ 15 ] SPECIFICATIONS GENERAL CCD Sensor: 1/3-inch Picture Elements CC3700S-2: 510 (H) x 492 (V) CC3700H-2: 768 (H) x 494 (V) Sensing Area: 6mm diagonal Synchronization System: AC line lock or internal oscillator Horizontal Resolution CC3700S-2, CC3700S-2X: 330 TV lines...

Page 16 - WARRANTY AND RETURN INFORMATION; Date

® Pelco, the Pelco logo, Spectra, Genex, Legacy, Esprit, and Camclosure are registered trademarks of Pelco. ™ HyperHAD and EXview HAD CCD are trademarks of the Sony Corporation. © Copyright 2002, Pelco. All rights reserved. WARRANTY AND RETURN INFORMATION REVISION HISTORY Manual # Date Comments C198...

Pelco CC3700H-2 - Manual

Table of Contents:

Summary

Other Pelco Models