Pelco IV SE SERIES - Manual
Pelco IV SE SERIES – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation
- Page 3 – Receiver; Active; Maximum Distance; 4 VAC/24VDC Wiring Distances; Total Watts
- Page 5 – Attach the back box leash to the lower dome.
- Page 8 – Troubleshooting; Check the signal with a volt meter or an oscilloscope.
- Page 9 – Switch Settings; Switch Settings for SW2; Special Systems
- Page 14 – ELECTRICAL; Specifications; GENERAL
- Page 15 – PRODUCT WARRANTY AND RETURN INFORMATION
I N S T A L L A T I O N
Spectra
®
IV Series
Spectra
®
IV SE Series
C3418M (8/06)
Pendant Mount Back Box
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
C3418M (8/06) 3 1. Install the mount for the pendant dome. Refer to the instructions supplied with the mount. 2. Open the hinged door to the back box. Push the tab lock towards the wall of the unit and lift the door open. Pull wiring into the back box. Refer to Table A, Table B, and Table C for wiri...
C3418M (8/06) 5 4. Connect wiring to the circuit board inside the back box. When finished, close the door to the back box and turn on the power. The green LED will light. NOTES: • Aux 1: Maximum 2 A at low voltage (<40 V) Aux 2: Maximum 30 mA at 32 VDC • If you are using both unshielded twisted p...
