Pelco IV SE SERIES - Manuals

8 C3418M (8/06) Troubleshooting If your dome does not power up properly after installation, use the following steps. 1. Check the fuse on the circuit board inside the back box for continuity. Replace the fuse if needed. 2. Check the wiring with a volt meter to ensure proper voltage is being received...

C3418M (8/06) 9 Switch Settings WARNING: If you are using D-type or P-type control, your system may not operate if the baud rate and address switches are not set correctly. The switches are set at the factory at the defaults for D-type control (2400 baud and address 1). Table D. Switch Settings for ...

14 C3418M (8/06) Weight (approximate) Back Box Standard Pendant 2.4 lb (1.09 kg) Environmental Pendant 3.5 lb (1.59 kg) Dome Drive 3.3 lb (1.48 kg) Lower Dome 0.2 lb (0.09 kg) ELECTRICAL (Dome Drive Only) Input Voltage 18-32 VAC; 24 VAC nominal22-27 VDC; 24 VDC nominal Input Power 24 VAC 23 VA nomin...

PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defectivein material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FR/FT/FS Series fiber optic p...