Pelco FR85011 - Manual

C1642M-A (1/05) 9 MODELS The FT85011/FR85011 fiber transmitter and receiver consist of the following series of m odels: Multimode Models: FT85011MSTR Single-channel fiber optic video transmitter/data transceiver; multimode, ST connector FR85011MSTR Single-channel fiber optic video receiver/data tran...

10 C1642M-A (1/05) FRONT PANEL The front panel of the FT85011 transmitter and the FR85011 receiver provides LED indicators that allow you to monitor data activity, signal status, and operating power (refer to Figure 2). Figure 2. Front Panel of FT85011 Transmitter and FR85011 Receiver DATA TX LED DA...

C1642M-A (1/05) 11 REAR PANEL All connections to the FT85011 transmitter and FR85011 receiver are made to the rear panel of the modules (refer to Figure 3). Figure 3. Rear Panel of FT85011 Transmitter and FR85011 Receiver RACK POWER/ALARM CONNECTOR, 4-pin connector for power/alarm connection of rack...

12 C1642M-A (1/05) Installation PACKAGE CONTENTS The following items are supplied: • With the FT85011 transmitter: 1 Regulated switching power supply with four plug adapters (North American, Australian, U.K., and European configurations); 100-240 VAC input, 12 VDC output 1 Wall clip with two 4-40 x ...

C1642M-A (1/05) 13 With the FT85011 transmitter/FR85011 receiver powered off, set the Data Selection switch to the required data communication using a small screwdriver. Refer to Table A for data commu-nication switch settings. Note the following: • The FT85011 transmitter/FR85011 receiver allows da...

14 C1642M-A (1/05) MOUNTING THE TRANSMITTER/RECEIVER INTO A RACK Optional fiber rack mount chassis, which can be mounted into an industry-standard 19-inch (48.26 cm) equipment rack, are designed for installation of multiple modules: • The RK5000PS-3U fiber rack mount chassis provides 12 module slots...

16 C1642M-A (1/05) CONNECTIONS Connections to the FT85011 transmitter and the FR85011 receiver are made on the rear panel of the modules and consist of the following: • Power connection NOTE: A 12 VDC or 24 VAC power supply can be used to power the transmitter/receiver when used as a standalone modu...

24 C1642M-A (1/05) Troubleshooting LED indicators on the front panel of the FT85011 transmitter/FR85011 receiver (refer to Figure 2) allow you to monitor signal status, data activity, and operating power. Table C pro-vides information about the front-panel indicators and associated troubleshooting g...

C1642M-A (1/05) 25 Video Present LED (Continued) Red on receiver Incoming video signal is not present on the channel. Optical signal is not being received from the transmitter. Carrier Detect LED is also red. Refer to the Carrier Detect LED troubleshooting section below. Video source is not powered ...

28 C1642M-A (1/05) Specifications VIDEO Number of Channels 1 Modulation Type Pulse code modulation, 8-bit resolution Video Input 1.0 Vp-p, 75 ohms; NTSC, PAL, and SECAM Bandwidth 6.5 MHz Gain Unity Differential Gain <2% Differential Phase <1° Tilt <1% Signal-to-Noise Ratio >60 dB (CCIR w...

PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic...