Pelco C1501M-A - Manual
Pelco C1501M-A – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Regulatory Notices; RADIO AND TELEVISION INTERFERENCE; Reorient or relocate the receiving antenna.
- Page 5 – Installation Instructions for CM9700-CC1-VID; Loosen and remove the top cover mounting screws.
- Page 6 – CC1 Internal Layout; UTILITY DISK SOFTWARE INSTALLATION; Insert the driver utility disk into the “A” drive of the CC1.; install; only
- Page 7 – PRODUCT WARRANTY AND RETURN INFORMATION; REVISION HISTORY
I N S T A L L A T I O N
CM9700-CC1-VID
VGA Video Card
C1501M-A (3/05)
C1501M-A.book Page 1 Wednesday, April 6, 2005 8:08 AM
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
C1501M-A (3/05) 3 Regulatory Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesire...
C1501M-A (3/05) 5 Installation Instructions for CM9700-CC1-VID 1. Turn off all power to the CC1. Disconnect and label all attached cabling. 2. Install the VGA card in the CC1. Refer to Figures 1 and 2 and do the following: a. Loosen and remove the top cover mounting screws. b. From the rear, tilt th...
6 C1501M-A (3/05) Figure 2. CC1 Internal Layout UTILITY DISK SOFTWARE INSTALLATION 1. If not done after installation of the VGA card, reconnect all cabling to the CC1. NOTE: A keyboard and monitor must be connected to the CC1 in order to install the driver software. 2. Apply power to the CC1. 3. Ins...
