Pelco C1501M-A - Manuals

Pelco C1501M-A – Manual in PDF format online.

Manuals:

Manual Pelco C1501M-A

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8

Summary

Page 3 - Regulatory Notices; RADIO AND TELEVISION INTERFERENCE; Reorient or relocate the receiving antenna.

C1501M-A (3/05) 3 Regulatory Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesire...

Page 5 - Installation Instructions for CM9700-CC1-VID; Loosen and remove the top cover mounting screws.

C1501M-A (3/05) 5 Installation Instructions for CM9700-CC1-VID 1. Turn off all power to the CC1. Disconnect and label all attached cabling. 2. Install the VGA card in the CC1. Refer to Figures 1 and 2 and do the following: a. Loosen and remove the top cover mounting screws. b. From the rear, tilt th...

Page 6 - CC1 Internal Layout; UTILITY DISK SOFTWARE INSTALLATION; Insert the driver utility disk into the “A” drive of the CC1.; install; only

6 C1501M-A (3/05) Figure 2. CC1 Internal Layout UTILITY DISK SOFTWARE INSTALLATION 1. If not done after installation of the VGA card, reconnect all cabling to the CC1. NOTE: A keyboard and monitor must be connected to the CC1 in order to install the driver software. 2. Apply power to the CC1. 3. Ins...

Pelco Manuals