Patton IM1/I - Manual

Patton IM1/I – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 2 – All warranty and nonwarranty repairs must be returned freight; This device is not intended to be; The Model IM1/I generates and uses radio frequency energy, and if
Page 3 – Corporate Headquarters; LAN; Remote/Satellite Office; Ethernet WAN Bridge; Figure 1. Typical Model IM1/I application
Page 5 – Installing the New QuickConnectTM Module; even pressure should be sufficient to seat the; CONNECTING TO THE 10BASE-T ETHERNET PORT
Page 6 – . 0 O P E R AT I O N; OPERATING INSTRUCTIONS; In order to operate, the Model IM1/I must be installed in the base; The Model IM1/I interface card has been
Page 7 – Quik-Connect Interface Module; Status LED; PATTON MODEL IM1/I SPECIFICATIONS
Page 8 – Patton Electronics Company

Loading the manual

U S E R
M A N UA L

M O D E L I M 1 / I

Ethernet Bridge Module

SALES OFFICE
(301) 975-1000
TECHNICAL SUPPORT
(301) 975-1007

http://www.patton.com

Part# 07MIM1I-D
Doc# 090101UD
Revised 7/29/99

An ISO-9001

Certified Company

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - All warranty and nonwarranty repairs must be returned freight; This device is not intended to be; The Model IM1/I generates and uses radio frequency energy, and if

2 1.3 SERVICE All warranty and nonwarranty repairs must be returned freight prepaid and insured to Patton Electronics. All returns must have aReturn Materials Authorization number on the outside of the shippingcontainer. This number may be obtained from Patton ElectronicsTechnical Service at: (301) ...

Page 3 - Corporate Headquarters; LAN; Remote/Satellite Office; Ethernet WAN Bridge; Figure 1. Typical Model IM1/I application

2.3 TYPICAL APPLICATION The Model IM1/I QuickConnect™ is designed to plug directly into the rear of a Patton Electronics baseband modem (i.e. Model 1090 or1092). The Model IM1/I is designed to be used as one of a pair ofunits. Figure 1 (below) illustrates a typical Model IM1/I installation. 2 2 .. 0...

Page 5 - Installing the New QuickConnectTM Module; even pressure should be sufficient to seat the; CONNECTING TO THE 10BASE-T ETHERNET PORT

3.1.2 Installing the New QuickConnect™ Module 1) Make sure the power switch on the base unit is off. Leave the power cord plugged into a grounded outlet to keep the unitgrounded. 2) Hold the module with the faceplate toward you and align the module with the guide slots in the rear panel of the base ...