Troubleshooting and Continued Safety Guidelines - Panasonic DMW BLK22 - Manual - Page 4
Table of Contents:
- Page 1 – Product Introduction, Parts Diagram, Basic Operation
- Page 2 – Mounting Plates Installation and Battery Mounting
- Page 3 – Charging Procedures, Tips, and Safety Precautions
- Page 4 – Troubleshooting and Continued Safety Guidelines
- Page 5 – Specifications and Warranty Information
- Page 6 – Appendix 1: ILC Compatibility Illustration
- Page 7 – Appendix 2: ILC Compatibility Illustration
- Page 8 – Appendix 3: Canon Compatibility Illustration
- Page 9 – Appendix 4: Nikon Compatibility Illustration
- Page 10 – Appendix 5: Sony Compatibility Illustration
3. Disconnect the charger from power when not in use.
4. Disconnect the charger from power before cleaning.
5. Use the Booster Button with 7.2V/7.4V Li-ion batteries only. Do not attempt the boost procedure with other batteries.
6. Use this device exclusively with the included AC power adapter. Do not use if the power adapter's wires are frayed or damaged or if the plugs are damaged.
7. Never connect the Traveler Flex to an outlet or power source with voltage above 240 Volts or below 100 Volts.
8. Do not touch with wet hands and keep the charger away from moisture and liquids. Do not allow it to get wet or submerge it.
9. Avoid contact with solvents, gasoline, grease, oil, paint, and detergents.
10. Do not operate near flammable liquids.
11. Do not disassemble, open the housing, or attempt to repair yourself.
Troubleshooting
The red (charge) LED indicator does not illuminate when the charger is connected to a power source and a battery has been inserted.
- The battery may not have been properly inserted. Unplug the charger from the power source and make sure that the battery is seated properly. Double-check to ensure that the polarities match before plugging the charger in again.
- Make sure the barrel plug of the AC adapter is properly and fully connected to the charger's Power Input (DC IN) Socket (1).
- Make sure that the metal contacts on both the battery and charger are clean. If not, wipe the contacts with a soft, dry cloth.
The battery reaches a full charge very rapidly.
- The battery may not have been fully depleted before charging.
- The battery is reaching the end of its service life and should be replaced.
The battery is providing a reduced operating time after being fully charged.
- The battery may have sat idle without being charged for too long.
- The battery is about to reach the end of its service life. All rechargeable batteries will eventually wear out after being used for a certain number of cycles.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Panasonic DMW BLK22
Summary
Introduction to the ProMaster Traveler Flex Battery Charger, parts diagram identifying components like the Power Input Socket and LED Indicator, and initial setup steps.
Instructions for removing and installing Battery Mounting Plates on the base unit, including alignment and locking procedures. Details on mounting lithium-ion batteries by matching contact pins and polarity symbols.
Detailed steps for using the Booster Switch to revive low-voltage batteries, understanding charging modes like trickle charge, and safety guidelines. Includes maintenance tips such as cleaning contacts.
Tips
- Verify polarity symbols before inserting the battery to ensure proper connection.
- Use the booster switch only with 7.2V or 7.4V Li-ion batteries.
- Clean metal contacts with a dry cloth to maintain optimal performance.
- The charger supports a 100-240V input, making it suitable for global travel without a voltage converter.
