National Instruments NI TB-2709 - Manual
National Instruments NI TB-2709 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Caution; What You Need to Get Started; Cautions
- Page 3 – not; Installation
- Page 4 – DAQ Getting Started Guide; Signal Descriptions
- Page 5 – S Series User; Measuring Floating Signals
- Page 6 – Measuring Ground-Referenced Signals; S Series User Manual; Cabling Options; Configuration; Floating Source
- Page 7 – Pin Number
- Page 8 – Specifications
- Page 9 – Physical; Dimensions; Shock and Vibration; Random vibration; Environment; The NI TB-2709 is intended for indoor use only.
- Page 10 – Safety; Note; in the Certification column.; Waste Electrical and Electronic Equipment (WEEE); EU Customers; Where to Go for Support; you have access to everything from
INSTALLATION GUIDE
NI TB-2709
PXI Terminal Block for S Series Devices
This installation guide describes how to install and connect signals to the
NI TB-2709 terminal block for use with PXI-6123/6133 S Series devices.
The TB-2709 can also be used with the PXI-6122/6132 devices to access
the first four AI channels.
Introduction
The TB-2709 is a terminal block assembly consisting of nine SMB
connectors and a 14-pin I/O connector. The terminal block assembly
connects directly to the front panel of National Instruments PXI-6122,
PXI-6123, PXI-6132, and PXI-6133 devices, eliminating the need for an
external cable.
Figure 1.
TB-2709 Device View
1
Access Door to Configuration Switches
2
14-Pin I/O Connector (Digital Signals)
3
SMB Connectors (Analog Signals)
AI 0
AI 1
AI 2
AI
3
AI 4
AI 5
AI 6
AI 7
AI
S
TAR
T
TRIG
I
1
2
3
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
NI TB-2709 Installation Guide 2 ni.com The nine SMB connectors on the TB-2709 allow you to easily connect analog input signals to your National Instruments device. The 14-pin I/O connector located on the bottom of the TB-2709 allows access to digital signals. Caution The TB-2709 is not designed for ...
© National Instruments Corporation 3 NI TB-2709 Installation Guide Do not substitute parts or modify equipment. Because of the danger of introducing additional hazards, do not install unauthorized parts or modify the device. Return the device to National Instruments for service and repair to ensure ...
NI TB-2709 Installation Guide 4 ni.com To connect the terminal block to the PXI module I/O connector, refer to Figure 2 as you complete the following steps: 1. Install the PXI module into the chassis and tighten the two module screws. You must install the PXI device before connecting the TB-2709. Re...
