National Instruments NI PXI/PCI-5114 - Manual
National Instruments NI PXI/PCI-5114 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Vertical; Specification; Impedance and Coupling
- Page 3 – Voltage Levels; Accuracy
- Page 4 – Bandwidth and Transient Response
- Page 6 – Horizontal; Sample Clock
- Page 8 – Trigger
- Page 12 – TClk Specifications
- Page 13 – Waveform Specifications
- Page 15 – Software
- Page 16 – Environment
- Page 18 – EU Customers
- Page 19 – Physical
- Page 20 – Where to Go for Support
NI PXI/PCI-5114 Specifications
8-Bit 250 MS/s Digitizer
Unless otherwise noted, the following conditions were used for each
specification:
•
All filter settings
•
All impedance selections
•
Sample clock set to 250 MS/s
Typical values are representative of an average unit operating at room
temperature. Specifications are subject to change without notice. For the
most recent NI 5114 specifications, visit
ni.com/manuals
.
To access the NI 5114 documentation, including the
NI High-Speed
Digitizers Getting Started Guide
, which contains functional descriptions of
the NI 5114 signals, navigate to
Start»Programs»National Instruments»
NI-SCOPE»Documentation
.
Hot Surface
If the NI 5114 has been in use, it may exceed safe handling temperatures and
cause burns. Allow the NI 5114 to cool before removing it from the PXI chassis.
Contents
Analog Input (Channel 0 and Channel 1) ........................................ 2
Sample Clock ................................................................................... 6
Phase-Locked Loop (PLL) Reference Clock ................................... 7
CLK IN (Sample Clock and Reference Clock Input,
Front Panel Connector) ................................................................. 8
Reference (Stop) Trigger ................................................................. 8
TRIG (External Trigger, Front Panel Connector) ............................ 10
PFI 0 and PFI 1 (Programmable Function Interface,
AUX Front Panel Connectors) ............................................................. 10
TClk Specifications ................................................................................. 12
Waveform Specifications ........................................................................ 13
Calibration............................................................................................... 14
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
NI PXI/PCI-5114 Specifications 2 ni.com Power .......................................................................................................14Software ...................................................................................................15Environment ..............................
© National Instruments Corporation 3 NI PXI/PCI-5114 Specifications Voltage Levels Full Scale (FS) Input Range and Programmable Vertical Offset 50 Ω 1 M Ω — Range (V pk-pk ) Vertical Offset Range (V) Range (V pk-pk ) Vertical Offset Range (V) 0.04 ±0.8 0.04 ±0.8 0.1 ±0.8 0.1 ±0.8 0.2 ±0.8 0.2 ±0.8 0...
NI PXI/PCI-5114 Specifications 4 ni.com Figure 1. NI 5114 Frequency Response (Typical) Bandwidth and Transient Response Bandwidth (–3 dB) Range (V pk-pk ) Bandwidth Rise/Fall Time, Typical — All ranges except 0.04 125 MHz 2.8 ns 0.04 100 MHz 3.5 ns Bandwidth Limit Filter 20 MHz Noise Filter — AC Cou...
