Makita XRH03Z - User Manual

Page 2 - SPECIFICATIONS; Symbols

2 ENGLISH SPECIFICATIONS Model BHR202 Concrete 20 mm Steel 13 mm Capacities Wood 26 mm No load speed (min -1 ) 0 - 1,100 Blows per minute 0 - 4,000 Overall length 358 mm Net weight 3.2 kg Rated voltage D.C. 18 V • Due to our continuing programme of research and development, the specifications herein...

Page 3 - SPECIFIC SAFETY RULES

3 Personal Safety 10. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. ...

Page 4 - SAVE THESE INSTRUCTIONS.; Tips for maintaining maximum battery life

4 2. Use auxiliary handles supplied with the tool. Loss of control can cause personal injury. 3. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal p...

Page 5 - FUNCTIONAL DESCRIPTION; Installing or removing battery cartridge

5 FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge 1 2 3 008829 • Always switch off the tool before insertion or removal of the battery cartr...

Page 6 - Selecting the action mode; Rotation with hammering; Hammering only; Torque limiter; ASSEMBLY; Bit grease

6 • When not operating the tool, always set the reversing switch lever to the neutral position. Selecting the action mode Rotation with hammering 1 2 3 007575 For drilling in concrete, masonry, etc., depress the lock button and rotate the action mode changing knob to the symbol. Use a tungsten-carbi...

Page 7 - Depth gauge

7 1 2 001296 Insert the bit into the tool. Turn the bit and push it in until it engages. 1 2 007342 If the bit cannot be pushed in, remove the bit. Pull the chuck cover down a couple of times. Then insert the bit again. Turn the bit and push it in until it engages. After installing, always make sure...

Page 8 - OPERATION; Hammer drilling operation

8 attached to is as follows. Bit diameter Dust cup 5 6 mm - 14.5 mm Dust cup 9 12 mm - 16 mm 006382 OPERATION Hammer drilling operation 008833 Set the action mode changing knob to the symbol. Position the bit at the desired location for the hole, then pull the switch trigger. Do not force the tool. ...

Page 9 - MAINTENANCE; Replacing carbon brushes; ACCESSORIES

9 Use the optional drill chuck assembly. When installing it, refer to "Installing or removing the bit" described on the previous page. Set the action mode changing knob so that the pointer points to the symbol. CAUTION: • Never use "rotation with hammering" when the drill chuck assem...

Page 12 - Makita Corporation