Makita DPC7330 - Manual

Makita DPC7330

Makita DPC7330 Electric Saw – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
Page: / 68

Table of Contents:

  • Page 4 – In case one of the parts listed should not be included in the
  • Page 5 – SAFETY PRECAUTIONS; Intended use; people, and persons under the influence of alcohol, drugs or medi; General precautions; long as they are under the supervision of a qualified trainer.; Protective equipment
  • Page 6 – Putting into operation; possible dirt in the muffler area.
  • Page 7 – Cutoff discs; - Do not put the overheated Power Cut in dry grass or on any inflam
  • Page 8 – To prevent kickback, observe the following:; - Never cut with the section of the cutting disc shown in figure 15.; Be especially careful when reinserting the disc into cuts; Working behavior / Method of working; - When working with the Power Cut hold it firmly by the front and; Injury; - When cutting workpieces down to length use a firm support.
  • Page 10 – Transport and storage; to cool off completely. Note: Mufflers with catalytic converters
  • Page 11 – Maintenance; - Do not operate the Power Cut with a defective or modified; First aid; replace any items used from the first aid box.; Disposal and environmental protection; SERVICE
  • Page 12 – Technical data; Specific consumption at max. load per ISO 8893
  • Page 13 – Denomination of components; Filter cover for air filter and spark plug cap
  • Page 14 – Tighten the screw firmly (30 ± 2 Nm), as otherwise; Mounting the cutting disc; fit with the arbor or shaft. If the arbor hole is larger, it must be; PUTTING INTO OPERATION; Sequence
  • Page 15 – Installing the pressure water system; - Install the water connection as shown in figure. Push clamp
  • Page 16 – Fuels; The Power Cut uses mineral-oil products; Fuel mixture; In order to obtain an optimum engine output and to protect
  • Page 17 – FOLLOW THE SAFETY PRECAUTIONS!; Carefully clean the area around the fuel-tank filler neck to keep; AVOID SKIN AND EYE CONTACT; For preparing the fuel-oil mixture first mix the entire oil; The Storage of Fuel
  • Page 18 – Starting the engine; This model is fitted with a semiautomatic decompression valve
  • Page 19 – Stopping the engine; Grasp the tubular handle firmly with one hand and press the; Pull the starter cable strong and rapidly until you hear the
  • Page 21 – MAINTENANCE
  • Page 22 – Cleaning the protection hood; ”Mounting the cutting; Cleaning / changing the air filter; carefully remove the filter cover (
  • Page 24 – Checking the ignition spark; Do not insert the combination tool into the spark plug hole,; Replacing the suction head; three months in order to ensure unimpeded fuel flow to the; Replacing the spark plug; Do not touch the spark plug or plug cap if the engine is; Remove the filter cover and hood. See; the air filter
  • Page 25 – Replacing the starter cable; Repeat three times
  • Page 26 – Be extremely careful - the return spring
  • Page 28 – Replacing/cleaning the spark arrester screen; section of the muffler (
  • Page 29 – Diamond cutting discs; except metal; nificantly. This in turn leads to lower operating costs (fuel; SPECIAL ACCESSORIES; Water tank; involving frequent site changes. For filling or for fast changing; Mains/pressure water system
  • Page 30 – Instructions for periodic maintenance; Service, spare parts and guarantee; Maintenance and repair
  • Page 31 – Troubleshooting; Guarantee; Malfunction
  • Page 32 – Extract from the spare parts list; Use only original MAKITA parts. For repairs and
  • Page 35 – Sommaire; Nettoyer / remplacer le filtre à air; Emballage; Nous vous remercions de votre confiance!; • construction robuste et haute fiabilité.
  • Page 36 – Si un des composants indiqués ici ne devait pas être dans la
  • Page 37 – INSTRUCTIONS DE SÉCURITÉ; Utilisation conforme aux prescriptions; insuffisamment informés et formés présentent un danger pour; Equipement de protection personnel; (A). Le casque de protection doit régulièrement être vérifié
  • Page 39 – Disques à découper; les matériaux prédéfinis. Le type de disque correspondant doit
  • Page 40 – Pour éviter tout rebond, respecter les consignes suivan-; Comportement et technique de travail; Attention risque de blessure!
  • Page 41 – L’enduit à mortier, la pierre ou le béton entraînent une très fine
  • Page 42 – Transport et stockage
  • Page 43 – - Vérifier avant de commencer à travailler si l’état de la dé; Premier secours
  • Page 44 – Caractéristiques techniques; Capacité réservoir carburant
  • Page 45 – Désignation des pièces; Couvercle de filtre pour filtre à air et fiche de bougie
  • Page 46 – Monter le disque à découper; MISE EN ROUTE
  • Page 47 – Montage du système à eau sous pression
  • Page 48 – Mélange carburant; MAKITA, ceci signifie mélanger 50 parties
  • Page 49 – Remplissage des réservoirs; ATTENTION: RESPECTER IMPERATIVEMENT LES; Stockage de carburants
  • Page 50 – Démarrer le moteur; à l’intérieur des butées dans les deux sens de la flèche.; Démarrage à froid
  • Page 51 – Arrêter le moteur; Tirer vite et fort sur le cordon de lancement, jusqu’au dé-; Démarrage à chaud
  • Page 52 – Réglage du carburateur
  • Page 53 – TRAVAUX DE MAINTENANCE; Remplacer la courroie
  • Page 54 – Nettoyer le capot de protection; Montage; des aiguilles et retirer avec précaution le couvercle du filtre
  • Page 56 – moyen d’un crochet en fil métallique.; Remplacement de bougie; d’huile, il faut procéder à un remplacement de la bougie (N° de
  • Page 57 – Remplacement du cordon de lancement; de long), comme montré sur la figure (sans oublier la rondelle; Répéter trois fois
  • Page 58 – Monter le déflecteur de ventilateur (voir chapitre „Remplacement
  • Page 59 – ) comme montré sur la figure jusqu’à ce que le capot
  • Page 60 – Changement / nettoyage du pare-étincelles; Il faut vérifier et nettoyer régulièrement le pare-étincelles.
  • Page 61 – Disques à découper en diamant; à l’exception du métal; ACCESSOIRES OPTIONNELS; Le réservoir d’eau; le réservoir ou utiliser des réservoirs de rechange, il suffit; La conduite d’eau au réseau / réservoir; N° de commande voir „Accessoires“.; Le chariot de guidage; illustration (*) dans le chapitre « Extrait de la liste des pièces
  • Page 62 – Indications de maintenance et d’entretien périodiques; Service d’atelier, pièces de rechange et garantie; Maintenance et réparations
  • Page 63 – Recherche de pannes; Panne; ou démarre difficilement; Garantie
  • Page 64 – Extrait de la liste des pièces de rechange
  • Page 68 – DOLMAR Division
Loading the manual

WARNING!

Read and understand this Manual. Always follow safety precautions in the Instruction and

Safety Manual. Improper use can cause serious injury!

The engine exhaust from this product contains chemicals known to the State of California to cause

cancer, birth defects or other reproductive harm. Preserve this Manual carefully!

ATTENTION!

Suivez toujours les conseils de sécurité du présent manuel d’instructions et de sécurité.

Une utilisation incorrecte de la découpeuse peut entraîner des blessures graves!

Conservez avec soin ce manuel! Les gaz d’échappement émis par ce produit contiennent des produits

chimiques connus par l’Etat de Californie pour provoquer le cancer, des défauts de naissance ou autres

dommages de reproduction. Lisez et comprenez ce manuel.

DPC6430, 6431, 6440, 6441

DPC7330, 7331, 7340, 7341

DPC8131, 8132

Instruction and Safety Manual

for Gasoline Power Cuts

(page 2 - 33)

Manuel d’instructions et de sécurité

de découpeuse thermiques

(page 34 - 65)

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 4 - In case one of the parts listed should not be included in the

4 6 5 4 3 2 1 Delivery inventory 1. Power Cut2. Cutting disc3. Adapter ring 0.8"/1.0" (not in the general scope of delivery. Country-specific) 4. Screwdriver (for carburetor adjustment) 5. Offset screwdriver6. Universal wrench 13/197. Instruction manual (not shown) Symbols You will notice th...

Page 5 - SAFETY PRECAUTIONS; Intended use; people, and persons under the influence of alcohol, drugs or medi; General precautions; long as they are under the supervision of a qualified trainer.; Protective equipment

5 2 3 1 4 SAFETY PRECAUTIONS Intended use Power Cut Use the Power Cut cutoff saw outdoors only, for trimming and cutting suitable materials, using cutting discs rated for this machine. Improper use: Never use the cutoff saw cutting discs for grinding or sanding (using the side of the cutting disc to...

Page 6 - Putting into operation; possible dirt in the muffler area.

6 - Always wear safety shoes or boots (G) with steel toes, non-skid soles, and leg protectors when working with the Power Cut. Safety shoes equipped with a protective layer provide protection against cuts and ensure a secure footing. - Always wear a work suit (H) of tough material with sufficient fl...

Other Makita Electric Saws Models

All Makita Electric Saws