Husqvarna 525iHF3 - User Manual

you are able to call for help in the event of an accident. • Always inspect the working area. Remove all loose objects such as stones, broken glass, nails, steel wire, string, etcetera, that could be thrown out or become wrapped around the cutting attachment. • Make sure that you can move and stand ...

Approved protective goggles must comply with the ANSI Z87.1 standard in the USAs or EN 166 in EU countries. • Use a visor for face protection. A visor is not enough for protection of the eyes. + • Use gloves when necessary, for example when you attach, examine or clean the cutting equipment. • Use s...

2. Push the power trigger lockout forward (A) and down. Hold the power trigger lockout against the handle (B) and make sure that it returns to its original position when you release it. B A 3. Make sure that the power trigger and the power trigger lockout moves freely and that the return springs ope...

Battery charger safety WARNING: Read the warning instructions that follow before you use the product. • Risk of electrical shock or short circuit if the safety instructions are not obeyed. • Do not use other battery chargers than the one supplied for your product. Only use Husqvarna chargers when yo...

CAUTION: Make sure that the drive shaft (C) engages with the gear in the cutting unit. 3. Tighten the screw (A) with your fingers. Make sure that screw (A) goes into the hole in the shaft. 4. Tighten the screw (A) fully.5. Tighten the screw (B) fully. Operation Introduction WARNING: Read and underst...

4. Hold the product near your body for a stable work position. 5. Make sure that the tip of the cutting equipment does not touch the ground. 6. Be careful and work slowly until all the branches are correctly cut. To stop the product 1. Release the power trigger or the power trigger lockout. 2. Put t...

Maintenance Introduction WARNING: Before you do any maintenance work you must read and understand the safety chapter. Maintenance schedule WARNING: Remove the battery before you do maintenance. Maintenance Before use Weekly Monthly Clean the external parts of the product. X Examine that the start an...

To lubricate the gear housing WARNING: Do not touch the gear housing immediately after operation of the product. The gear housing is hot and can cause injury. • Use Husqvarna special grease. Speak to your servicing dealer for more information about recommended grease. • Add the grease through the gr...

Problem Possible faults Possible action Error LED flashes red Overload. The cutting attachment is jammed. Stop the product. Remove the battery. Clean the cut- ting attachment from unwanted materials. Temperature deviation. Let the product cool down. The power trigger and the acti- vate button are pr...

Technical data Technical data 525iHF3 Motor Motor type Husqvarna E-torq BLDC Speed of output shaft, 1/min 5800 Weight Weight without battery, kg/lb 5.7/12.6 Weight including battery BLi200, kg/lb 7.1/15.7 Blades Type Double sided Cutting length, inch/mm 25.5/650 Cutting speed, cuts/min 4200 Noise em...

525iHF3 Output power 4 , max dBm 0 Approved batteries Battery BLi200 40-B220X Type Lithium-ion Lithium-ion Battery capacity, Ah 5.2 6.0 Nominal voltage, V 36 36 Weight, kg (lb) 1.3 (2.9) 1.4 (3.1) Approved battery chargers Battery charger QC330 Input voltage, V 100-240 Frequency, Hz 50-60 Power, W 3...

Declaration of Conformity EU Declaration of Conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Battery-operated extended reach Hedge Trimmer Brand Husqvarna Type / Model 525iHF3 Identification Serial numbers ...