Husqvarna 525HE4 - User Manual

• Never use a product that has been modified in any way from its original specification. Safety instructions for operation WARNING: Read the warning instructions that follow before you use the product. • Never use the product in extreme weather conditions such as severe cold, very hot and/or humid c...

• Keep first aid equipment close at hand. Safety devices on the product WARNING: Read the warning instructions that follow before you use the product. • Do not use a product with safety devices that are damaged or do not operate correctly. • Do a check of the safety devices regularly. If the safety ...

To do a check of the muffler The muffler keeps noise levels to a minimum and sends exhaust fumes away from the operator.• Do a visual check for damage and deformation.• Make sure that the muffler is correctly attached to the product. • If the muffler on your product has a spark arrester screen, do a...

• Remove the spark plug cap before you put the product into storage to make sure that the engine does not start accidentally. Safety instructions for maintenance WARNING: Read the warning instructions that follow before you use the product. • Stop the engine and make sure that the cutting equipment ...

3. Adjust the length of the harness until the support hook is level with your hip. Operation Introduction WARNING: Before you operate the product, you must read and understand the safety chapter. To do before you operate the product • Examine the work area and remove loose objects.• Do a check of th...

20 0.40 CAUTION: Small errors can influence the ratio of the mixture drastically when you mix small quantities of fuel. Measure the quantity of oil carefully and make sure that you get the correct mixture. 1. Fill half the quantity of gasoline in a clean container for fuel. 2. Add the full quantity ...

4. Tilt the cutting unit to the applicable position. 5. Adjust the screw to set the friction.6. Set the cutting unit in different positions to try the friction. To set the product in transport position WARNING: Do not start the product when the product is in transport position. 1. Push the stop swit...

Troubleshooting Troubleshooting The engine does not start Problem Possible cause Recommended step Starter pawls The starter pawls cannot move freely. Adjust or replace the starter pawls. Clean around the starter pawls. Speak to an approved servicing dealer. Fuel tank Incorrect fuel type. Drain it an...

Blade Problem Possible causes Recommended step The blade becomes hot. There is friction between the blades. Remove burrs from the blade and lubricate the blade. Refer to To examine the blades on page 16. Transportation, storage and disposal Transportation and storage • Always allow the product to co...

Declaration of Conformity EU Declaration of Conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declares on our sole responsibility that the product: Description Hedge trimmers Brand Husqvarna Type/Model 525HE3, 525HE4 Identification Serial numbers dating from 2022 and onwa...

UK Declaration of conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Hedge trimmers Brand Husqvarna Type / Model 525HE3, 525HE4 Identification Serial numbers dating from 2022 and onwards complies fully with t...