Human Touch HT-270 - Manual
Human Touch HT-270 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
REMOVING THE BACKREST COVER
1. Use the remote control to raise the backrest to a fully upright position.
2. Power off the chair and unplug it.
3. Using a Phillips-head screwdriver, remove the two screws that secure the remote control bracket
to the backrest cover (Fig.1).
4. Pull the remote control cables through the backrest cover, then disconnect the cables.
5. Using a 5/32" (4mm)
""
Allen key, remove the four backrest cover screws. (Fig.2).
6. Tip the backrest cover backward then lay it carefully
on the floor behind the chair.
7. Disconnect the three connectors (Fig.3).
8. Remove the backrest cover.
Tools Required: 5/32" (4mm) Allen key
""
, Phillips-head screwdriver
(4mm) Allen key
(4mm) Allen key
NOTE: SAVE ALL SCREWS FOR USE DURING REASSEMBLY.
REPLACING THE BACKREST COVER
H T -270
06/01/08
(Fig.1)
(Fig.2)
(Fig.3)
1
To ensure that Human Touch
®
products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
SERVICE LEVEL: 2
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
