Human Touch HT-135/136 - Manual

GET READY

Tools Required: Small Phillips-head screwdriver, short-handled Phillips-head screwdriver

REMOVING THE ACTUATOR

1. Locate the connector box underneath the chair on the right-hand side (Fig.2).

2. Using a small Phillips-head screwdriver, remove the two screws that secure

the connector box cover, then remove the cover.
3. Disconnect the larger of the two connectors inside.

SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY

1. Push down on the backrest release lever, then fold the backrest forward onto
the chair seat (Fig.1).
2. Power off the chair and unplug it.

(Fig.2)

Connector box

(Right-hand of the chair)

06/01/08

REPLACING THE BACKREST ACTUATOR

H T -135/136

1

Backrest release lever

(Fig.1)

To ensure that Human Touch

®

products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all

product repairs are performed using only factory-new parts and in accordance with these product repair instructions.

SERVICE LEVEL: 3