Fluke FLUKE-9040 - User Manual

1 9040 Introduction The Fluke 9040 Phase Rotation Indicator (the 9040) is a handheld instrument designed to detect the rotary field of three-phase systems. How to Contact Fluke To contact Fluke, call one of the following telephone numbers: • Technical Support USA: 1-800-44-FLUKE (1-800-443-5853) • C...

9040 Users Manual 2 Unpacking the 9040 The 9040 is available in three configurations. Depending on your purchase, the 9040 ships with these items: • 9040 o 3 self-retaining test probes, 1000 V CAT II o 3 alligator clips, 1000 V CAT III/600 V CAT IV o Users Manual • 9040UK o 3 fused test probes, 1000...

Phase Rotation Indicator Safety Information 3 Safety Information Caution identifies conditions and actions that may damage the 9040. Warning identifies conditions and actions that pose hazard(s) to the user. XW Warning To prevent possible electrical shock, fire, or personal injury: • Carefully read ...

9040 Users Manual 4 • Measurements can be adversely affected by impedances of additional operating circuits connected in parallel or by transient currents. • Verify operation prior to measuring hazardous voltages (voltages above 30 V ac rms, 42 V ac peak and 60 V dc). • Do not use the 9040 with any ...

Phase Rotation Indicator Symbols 5 Symbols The following symbols appear on the 9040 or in this manual. Table 1. Symbols W Risk of Danger. Important information. See manual. J Earth ground. X Hazardous voltage. Risk of electric shock. T Double Insulated. P Conforms to requirements of European Union. ...

9040 Users Manual 6 Elements of the 9040 Indicators, buttons, and jacks are shown in Figure 1. Test lead input jack L1, L2, L3 Indicators Clockwise Rotation LCD Indicator Counter-Clockwise Rotation LCD Indicator Brief Instructions on instrument rear bbx02f.eps Figure 1. The 9040 Phase Rotation Indic...

Phase Rotation Indicator Determine the Rotary Field Direction 7 Determine the Rotary Field Direction To determine the rotary field direction: 1. Connect the test probes to the end of the test leads. 2. Connect the test probes to the three mains phases. 3. The green ON indicator shows that the instru...

9040 Users Manual 8 Maintaining the 9040 W Caution To prevent damage to the 9040: • Do not attempt to repair or service the 9040 unless qualified to do so. • Make sure that the relevant calibration, performance test, and service information is being used. • Do not use abrasives or solvents. Abrasive...

Phase Rotation Indicator Replacing the Fuse (9040UK only) 9 Replacing the Fuse (9040UK only) XW Warning For safe operation and maintenance of the product: • Use only specified replacement fuses. See Specifications section. • Before you replace the fuse, disconnect the accessory (cable or probe) at b...

9040 Users Manual 10 Specifications Environmental Operating Temperature 0 ° C to +40 ° C Pollution Degree 2 Type of Protection IP 40 Mechanical Specifications Size 124 x 61 x 27 mm (4.9 x 2.4 x 1.1 in) Weight 200 g (0.44 lb) Fuse 500 mA / 1000 V/ FF / 50 kA / 6.3 x 32 mm (0.25 x 1.26 in) Electrical ...