Page 2 - LIMITED WARRANTY AND LIMITATION OF LIABILITY
LIMITED WARRANTY AND LIMITATION OF LIABILITY Each Fluke Networks product is warranted to be free from defects in material and workmanship under normal use and service. The warranty period for the mainframe is 18 months and begins on the date of purchase. Parts, accessories, product repairs and servi...
Page 3 - Contents; Introduction; Contacting Fluke Networks; Safety Information
1 TS ® 19 Portable Test Telephone Contents Title Page Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Registration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Contacting Fluke Networks . . . . . . . . . . . . . . . . . 1 Safety Information . . . . . . . . ...
Page 4 - WX; Warning; Physical Characteristics; Handgrip Controls
2 TS19 Portable Test TelephoneUsers Guide WX Warning Good safety practices prohibit the connection of the TS19 and similar test sets to 117 volts AC commercial electrical power; should the TS19 be connected to commercial power, all warranties are voided. The TS19 Portable Test Telephone is not desig...
Page 5 - Keypad Controls and Indicators; Cords
3 Keypad Controls and Indicators B HI Z/RING/TALK Switch: This three-position slide switch is labeled as HI Z for high impedance monitoring, RING for ringer and low impedance monitoring, and TALK for talk. • In the HI Z position, the TS19 is on hook with a high impedance coupling to the telephone li...
Page 6 - Operation; Troubleshooting
4 TS19 Portable Test TelephoneUsers Guide C Ground Start Cord: This cord consists of two conductors with alligator clips. In addition, the red (ring) conductor has a banana jack attached. This jack is located six inches below the Portable Test Telephone and is partially covered by the outer fabric o...
Page 7 - Maintenance; Belt Clip Replacement
5 Maintenance To locate a short circuit: Open one side of the telephone line and place the test set in the loop — one lead to each side of the opened line. On the CO side of the fault, a loud click will be heard. On the field side of the fault, no click will be heard. To locate an open circuit: Brid...
Page 8 - Specifications
6 TS19 Portable Test TelephoneUsers Guide Specifications Electrical Loop Limit 2.4 k Ω maximum at 48 VDC (nominal 15 mA minimum loop current) DC Resistance (Talk Mode) 150 Ω typical at 80 mA current AC Impedance (Monitor Mode) Low impedance (Ring position) 600 Ω at 1 KHz typical High impedance (HI Z...