Dewalt DP2800- User Manual

5 E n g lis h RISk to BReAthING (ASPhyxIAtIoN) coNtINueD • Some cleaning fluids contain substances which could cause injury to skin, eyes or lungs. • Use only cleaning fluids specifically recommended for high-pressure washers. Follow manufacturers recommendations. Do not use chlorine bleach or any o...

6 E n g li sh DANGeR: RISk of uNSAfe oPeRAtIoN WHat can HaPPen HoW to PreVent It • Unsafe operation of your pressure washer could lead to serious injury or death to you or others. • Do not use chlorine bleach or any other corrosive compound. • Become familiar with the operation and controls of the p...

7 E n g lis h • If proper starting procedure is not followed, engine can kickback causing serious hand and arm injury. • If engine does not start after two pulls, squeeze trigger of gun to relieve pump pressure. Pull starter cord slowly until resistance is felt. Then pull cord rapidly to avoid kickb...

8 E n g li sh WARNING: RISk of BuRStING WHat can HaPPen HoW to PreVent It • Over inflation of tires could result in serious injury and property damage. • Use a tire pressure gauge to check the tires pressure before each use and while inflating tires; see the tire side- wall for the correct tire pres...

9 E n g lis h WARNING: RISk of electRIcAl Shock WHat can HaPPen HoW to PreVent It • Spray directed at electrical outlets or switches, or objects connected to an electrical circuit, could result in a fatal electrical shock. • Unplug any electrically operated product before attempting to clean it. Dir...

10 E n g li sh oPErATIonPressure Adjustments The pressure setting is preset at the factory to achieve optimum pres- sure and cleaning. To lower the pressure, follow these instructions. 1. Back away from the surface to be cleaned. The further away you are, the less the pressure will be on the surface...

11 E n g lis h 1. Pull quick-connect coupler back and insert nozzle. . Release quick-connect coupler and twist nozzle to make sure it is secure in coupler. WARNING: Flying object could cause risk of serious injury. Ensure nozzle is completely inserted in quick-connect socket and quick- connect snap ...

1 E n g li sh • NEvER turn water supply off while pressure washer engine is running or damage to pump will result. • DO NOT stop spraying water for more than two T minutes at a time. Pump operates in bypass mode when spray gun trigger is not pressed. When the temperature inside the pump rises too hi...

13 E n g lis h cAutIoN: Risk of property damage Failure to do so could cause damage to the pump. . Turn engine off. Refer to the engine instruction manual. cAutIoN: Risk of property damage. NEvER turn water supply off while pressure washer engine is running or damage to pump will result. 3. Turn wat...

14 E n g li sh 3. Disconnect the spray wand from the gun. Z 4. Remove the high-pressure nozzle from the spray wand. Remove any obstructions with the nozzle cleaning tool (Z) provided and back flush with clean water. 5. Direct water supply into spray wand to back flush loosened particles for 30 secon...

15 E n g lis h Pressure Washer 1. Drain all water from high- pressure hose, coil it and store it in cradle of the pressure washer handle. . With nozzle pointed down and the spray gun and wand in a vertical position, squeeze trigger to drain all water from spray gun and wand. Store in gun holder. 3. ...

16 E n g li sh Free WarnInG LaBeL rePLaceMent: If your warning labels become illegible or are missing, call 1-800-4-D e WALT for a free replacement.

18 E n g li sh Troubleshooting Guide This section provides a list of the more frequently encountered malfunctions, their causes and corrective actions. The operator or maintenance personnel can perform some corrective actions, and others may require the assistance of a qualified D e WALT technician ...

19 E n g lis h Troubleshooting codes coDe PossIBLe cause PossIBLe soLutIon 1 No fuel. Add fuel. Low oil. Add required amount of oil. 3 Pressure builds up after two pulls on the recoil starter or after initial use. Squeeze gun trigger to relieve pressure. 4 Choke lever in the NO CHOKE position. Move ...