Crimestopper TN-4003 - Manual

Page 3 - INSTALLATION CAUTIONS & WARNINGS; , check all vehicle manufacturer cautions and warnings; CONTROL MODULE & COMPONENT MOUNTING; The TrakNet

3 INSTALLATION CAUTIONS & WARNINGS BEFORE BEGINNING , check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS, ABS BRAKES, ENGINE COMPUTERS, and BATTERY etc.). WE RECOMMEND the use of a VOLT/OHM METER to test and verify wiring circuits. Test lights or illumina...

Page 4 - The TrakNet unit has an internal power management program that; MOUNTING LOCATION; installer. These items are normally not used by the owner.

4 CONTROL MODULE & COMPONENT MOUNTING Main Unit: The TrakNet unit has an internal power management program that monitors the vehicle power at all times. The internal power management program is continuously looking at the condition of the battery in order to detect the state of the vehicle opera...

Page 5 - Selecting the Antenna Locations

5 MOUNTING LOCATION Selecting the Antenna Locations The Module requires two antennas elements. One antenna is for receiving GPS signals from The Navistar GPS satellites. The second antenna is a radio transceiver antenna that communicates with the Cellular network. The antenna does not require a gro ...

Page 6 - INSTALLATION; Locating Vehicle Power; Powering the Unit for the First Time

6 INSTALLATION Locating Vehicle Power The TRAKNET has an internal power management program that monitors the vehicle power at all times. The internal power management program is continuously looking at the condition of the vehicle battery in order to detect the state of the vehicle operation. The TR...

Page 7 - Confirming Proper Operation

7 INSTALLATION Within five minutes the flash rate will change to approximately one second on and one second off to indicate that the GPS Receiver has established a location “lock”. Within 1 minute the flash color should be green to indicate good cellular coverage. If you do not get the results above...

Page 8 - LED STATUS INDICATOR; It is highly recommended to perform a location request and other

8 LED STATUS INDICATOR LED Status Indicator BI-COLOR ON BOARD LED: This unit has a bi-colored LED on unit. SOLID LED C OLOR: Solid Green – Device is in Test Mode: no inputs are currently being triggered. Solid Orange – Device is in Test Mode: At least one input is currently being triggered. Solid Re...

Page 9 - WIRING; Chassis Ground Input; THIS WIRE MUST BE CONNECTED TO TH E CHASSIS METAL OF THE VEHICLE.

9 WIRING NOTE: Some Options Need to Be Pre -programmed From Crimestopper prior to installing the unit. Pin 1 Black: Chassis Ground Input THIS WIRE MUST BE CONNECTED TO TH E CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt to ensure a good connection. Pin 2 Green: Starter Disable (-) (Outp...

Page 10 - Triggers alarm input of tracking device if received a negative

10 WIRING Pin 12 Orange: Alarm Trigger (-) Default* or Door Open/Close Input #1 A. Alarm Trigger *: Triggers alarm input of tracking device if received a negative input for 15 seconds or longer. This is connected to the negative siren output, if alarm has positive siren output use a relay to convert...

Page 11 - WIRING DIAGRAM

Page 12 - ACCESS INFORMATION; • Enter customer login and password. Then click login.

ACCESS INFORMATION Cong ratulations, you have just installed the Internet based vehicle telematics system. Now that it’s installed, here’s how to use your system. Step #1 First fill out your TrakNet registration form and fax to 805.581 -9500. Then you will receive a call or email with your login and...

Crimestopper TN-4003 - Manual

Table of Contents:

Summary

Other Crimestopper Models