Crimestopper CS-880 OEM - Manual
Crimestopper CS-880 OEM – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WIRING; Connect to RED siren wire. Siren included with CS -880S OEM; OPERATION
- Page 3 – After the 15 Second delay the system will; SEE CHART ON NEXT PAGE FOR OPTION
- Page 4 – TO TURN A FEATURE ON:; PROGRAMMING; DOOR OPEN WARNING
+
CS-880 OEM
ALARM UPGRADE FOR
FACTORY REMOTE KEYLESS ENTRY SYSTEM
INSTALLATION PRECAUTIONS & WARNINGS
NOTE:
This system does not improve or affect the range of the factory
remote keyles s entry transmitters. This is an ADD-ON system only. The
arm/disarm range of this system will be identical to the factory keyless
lock/unlock range.
BEFORE BEGINNING
, check all vehicle manufacturer cautions and
warnings regarding electrical service (AIR BAGS, ABS BRAKES, AND
BATTERY).
DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED
with brake, and gas pedals, steering column, or any other moving parts
in the vehicle.
SUGGESTED COMPONENT MOUNTING
CONTROL MODULE: Underdash Mounting:
If you are locating the
control unit underdash, Try to conceal module away from any intruders.
DO NOT Mount the control unit or wiring harness where they can
become entangled with moving parts such as brake/gas/clutch
pedals, or the steering column.
LED:
Mount the red
LED
in a visible location on the dashboard or
console.
Shock Sensor:
Mount the included shock sensor with wire ties to an
under dash wire harness or fasten a panel.
Disarm/Program Button:
Mount the
Override/Program
push-button in
a hidden location easily accessible to the user in case the system must
be disarmed without the use of the transmitter. This switch is also used
to program certain features.
SIREN (CS - 880S OEM Model):
Mount the siren under the hood to inner
fender- well or other body surface with the open end facing downward.
TECH SUPPORT
Mon-Fri 8:00 AM-4:30 PM Pacific Time
(800) 998-6880
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
WIRING YELLOW WIRE: IGNITION SWITCHED “ON” AND “START” +12 VOLTS Connect to an Ignition wire that shows +12 Volts when the key in both “On” and “Start” pos itions. VIOLET WIRE: (+) DOOR TRIGGER Connect to Positive type door circuits that show 12 Volts when a door is opened such as on Ford/Mercury ve...
PROGRAMMING 7. SHOCK SENSOR SETUP/TEST MODE This option allows easy adjustment and setup for the 880’s shock sensor. When set to this mode, simply leave the Ignition in the ON position and begin to produce impacts around various parts of the vehicle. If you are able to product and impact strong enou...
PROGRAMMING TO TURN A FEATURE ON: Once you are at the desired option number, turn the Ignition key OFF then back ON. After a few seconds, the siren will chirp and the lights will flash once to indicate the feature is ON. (See chart below for feature values) TO TURN A FEATURE OFF: Once you are at the...
