Crimestopper CS-865RKE - Manual
Crimestopper CS-865RKE – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS; Jumper Diagram......................................................................................................................7; PRE-INSTALLATION CONSIDERATIONS; BEFORE BEGINNING; column, or any other moving parts in the vehicle.
- Page 3 – COMPONENT MOUNTING; Mount the button in a hidden but accessible location. It is used for; WIRING; DEFAULT; output is POSITIVE. SEE PAGE 7
- Page 4 – ORANGE WIRE: NEGATIVE ARMED OUTPUT; POWER DOOR LOCK WIRING
- Page 5 – NEGATIVE TRIGGER DOORLOCK WIRING; AFTERMARKET ACTUATOR WIRING
- Page 6 – CS-865RKE SEPARATE DRIVER’S DOOR UNLOCK DIAGRAMS; DRIVER PRIORITY UNLOCK with NEGATIVE TYPE DOOR LOCKS; DRIVER PRIORITY UNLOCK with REV. POLARITY DOOR LOCKS
- Page 7 – JUMPER PIN DIAGRAM; SIDE VIEW; TOP VIEW OF JUMPER PINS; JUMPER
- Page 8 – SYSTEM WIRING DIAGRAM; PIN BLUE HARNESS
- Page 9 – CS-865RKE II TRANSMITTER PROGRAMMING; the lock button on a 3; learning the 4; WAIT FOR; PRESS LOCK BTN
- Page 10 – OPTION PROGRAMMING; PROGRAMMING OPTIONS CHART
- Page 11 – OPTION PROGRAMMING cont.; DOUBLE UNLOCK PULSE; This option turns the horn chirps for lock/unlock on or off.; EXTENDED HORN CHIRP; OPTION RESET
- Page 12 – OPERATION; LOCK; REMOTE LOCK
- Page 13 – REMOTE PANIC PROTECTION (OPTIONAL, REQUIRES HORN HONK FEATURE); IGNITION TRIGGER (OPTIONAL REQUIRES HORN HONK FEATURE); using the remote control; VALET MODE
- Page 14 – AUTO LOCK / UNLOCK WITH IGNITION
CS-865RKE Series II
REMOTE KEYLESS ENTRY SYSTEM
INSTALLATION & OPERATING INSTRUCTIONS
INTRODUCTION:
CONGRATULATIONS
on your choice of a Remote Keyless Entry System by Crimestopper Security Products
Inc. This booklet contains the information necessary for installing, and operating your system. If any
questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech Support
number below.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY FEATURES:
These are features that must be connected in order for the system to operate
properly i.e. Power & Ground, along with the Primary features of Power Locks & Flashing Lights.
-OPTIONAL FEATURES:
Optional features are connected only if desired or agreed upon by the installing
dealer i.e. Driver’s Separate Unlock, Horn Chirp, Dome light illumination, Trunk Pop, etc. These features may
require additional parts and labor charges. Consult with your installer and come to an agreement about your
optional features
before
installation. NOTE: The LED is required for programmable options. See page 10.
TECH SUPPORT
This device complies with FCC Rules part 15. Operation is subject to the
following two conditions: 1) This device may not cause interference, and (2)
this device must accept any interference that may be received, including
interference that may cause undesired operation. The manufacturer is not
responsible for any radio or TV interference caused by unauthorized
modification to this equipment. Such modification could void the user's
authority to operate the equipment.
Mon-Fri 8:00 AM-4:30 PM Pacific Time
(800) 998-6880
www.crimestopper.com
[email protected]
REV. B 03.2004
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TABLE OF CONTENTS Pre-Installation & Component Mounting……………………..…………………………………………………2-3 Wiring……..…………………………………………………………………………………………………….…….3-4 Power Door Lock Wiring……………………………………………………….………..……………….…..……4-6 Jumper Diagram……………………………………………………………………………………………………….7 System Wiring Diagram.………………………...
COMPONENT MOUNTING CONTROL MODULE: Locate the module underdash as high as possible. Driver’s Side usually provides an easy location for the majority of the wiring connections. The antenna wire should be routed away from any metal if possible. DO NOT alter the length of the antenna wire, or ground th...
WIRING ORANGE WIRE: NEGATIVE ARMED OUTPUT This wire provides a constant GROUND output when system is locked with the remote transmitter. This output can used for a starter disable relay, or a device such as a window roll-up module. See System Wiring Diagram. On page GRAY WIRE: (-) AUXILIARY REMOTE O...
