Crimestopper CS-2002DPII - Manual
Crimestopper CS-2002DPII – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS; Installation Cautions & Warnings...............................................................................................2; INSTALLATION CAUTIONS & WARNINGS; BEFORE BEGINNING; before jump starting, using a battery; DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED; with brake, and gas pedals, steering
- Page 4 – WIRING; BLACK WIRE: SYSTEM CHASSIS GROUND
- Page 5 – Connect to RED siren wire from the Siren in the engine compartment.; WHITE WIRE: PARKING LIGHT
- Page 6 – Mount the LED/Valet Pod in a visible location of the dash or console.; POWER DOOR LOCK WIRING; Determine the type of locking system the vehicle has
- Page 7 – NEGATIVE TRIGGER DOORLOCK WIRING
- Page 8 – SEPARATE DRIVER’S DOOR UNLOCK WIRING; NEGATIVE TRIGGER DOOR LOCKS
- Page 9 – TRANSMITTER PROGRAMMING; or 4; WAIT FOR; PRESS LOCK BUTTON
- Page 10 – OPTION PROGRAMMING; PROGRAMMING OPTIONS CHART; Enable
- Page 12 – DOUBLE UNLOCK PULSE
- Page 14 – OPERATING INSTRUCTIONS; BUTTON REMOTE TRANSMITTER:; ACTIVE ARMING; ALARM TRIGGERING
- Page 15 – REMOTE PANIC PROTECTION
- Page 16 – VALET MODE; Doors will not lock if they are open to prevent locking the keys in.
- Page 17 – CARJACK PROTECTION FEATURES; ACTIVE CARJACK
- Page 18 – LED; LED POD; DASH; OR
- Page 20 – DATA PORT DIAGRAM; Data Port; BCM; OBD connector
1
CS-2002DPII
With Data Port Technology
REMOTE CONTROL ALARM SYSTEM
INSTALLATION & OPERATING INSTRUCTIONS
INTRODUCTION
CONGRATULATIONS
on your choice of an “On-Guard” Remote Alarm System with DP Technology by
Crimestopper Security Products Inc. This booklet contains the information necessary for installing, using, and
maintaining your alarm system. If any questions arise, contact your installation dealer or Crimestopper
Security Products Inc. at the Tech Support number below.
*IMPORTANT INFORMATION: Primary and Optional Features:
-PRIMARY:
These are features that must be connected in order for the system to operate properly; i.e. the
Siren, +12V Power, Ground, Door pin, Flashing lights, LED/Valet Pod etc.
-OPTIONAL:
These are features to be connected if desired or agreed upon by the installing dealer. These
features may also require additional parts and/or labor fees. Consult with your installer beforehand; i.e. Door
Locks, Starter disable, Hood/Trunk trigger, and Auxiliary Remote Outputs etc.
This installation book is designed for the installer or individual with an existing understanding of automotive
electrical systems, along with the ability to test and connect wires for proper operation. To ease installation,
we suggest that you READ THIS MANUAL before beginning your installation. This book is provided as a
GENERAL GUIDLINE and the information contained herein may differ from your vehicle.
TECH SUPPORT
Mon-Fri 8:00 AM-4:30 PM Pacific Time
(800) 998-6880
REV. D 1.2007
This device complies with FCC Rules part 15. Operation is subject to
the following two conditions: 1) This device may not cause interference,
and (2) this device must accept any interference that may be received,
including interference that may cause undesired operation. The
manufacturer is not responsible for any radio or TV interference caused
by unauthorized modification to this equipment. Such modification
could void the user's authority to operate the equipment.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 TABLE OF CONTENTS Installation Cautions & Warnings…….……………………………….……………………………………………2 Control Module & Component Mounting……………...……………………..……………………….…………..3 Wiring……..……………………………………………………………………………………..……………….…….3-6 Parking Light Jumper Diagram……………………………………………….………………………….…..……..5 Power Doo...
4 WIRING BLACK WIRE: SYSTEM CHASSIS GROUND The Black wire MUST be connected the CHASSIS METAL of the vehicle. Scrape away any paint or debris from the connection point and use a star washer to ensure a good connection. Keep the ground wire short. YELLOW WIRE: IGNITION SWITCHED “ON” AND “START” +12 V...
5 WIRING BLUE/WHITE WIRE: (-) PASSENGER(S) DOOR UNLOCK OUTPUT (Optional, requires relay) Connects to unlock circuit for passenger door(s) when using separate driver’s door unlock option. See SEPARATE DRIVER’S DOOR UNLOCK W IRING on Page 8 for some configuration options. BROWN WIRE: (+) SIREN OUTPUT ...
