Crimestopper CS-2001FC - Manual
Crimestopper CS-2001FC – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS; Installation Cautions & Warnings..................................................................................................2; INSTALLATION CAUTIONS & WARNINGS; BEFORE BEGINNING; before jump starting, using a battery; DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED; column, or any other moving parts in the vehicle.
- Page 3 – CONTROL MODULE & COMPONENT MOUNTING; Mount the red LED in a visible location on the dashboard or console.; WIRING
- Page 4 – BLACK WIRE: SYSTEM CHASSIS GROUND
- Page 5 – Connect to RED siren wire from the Siren in the engine compartment.; WHITE WIRE: PARKING LIGHT
- Page 6 – Mount the LED in a visible location of the dash or console.; POWER DOOR LOCK WIRING
- Page 8 – SEPARATE DRIVER’S DOOR UNLOCK WIRING; NEGATIVE TRIGGER DOOR LOCKS
- Page 9 – TRANSMITTER PROGRAMMING; Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3; Button on a second or third remote at this time. (If needed); OR
- Page 10 – OPTION PROGRAMMING; PROGRAMMING OPTIONS CHART
- Page 11 – Doors will not lock if they are open to prevent locking the keys in
- Page 12 – DOUBLE UNLOCK PULSE
- Page 13 – on this alarm system. Press the program button 2-15 times only.
- Page 14 – REMOTE CONTROL; BUTTON REMOTE TRANSMITTER:; OPERATING INSTRUCTIONS; ACTIVE ARMING
- Page 15 – REMOTE PANIC PROTECTION
- Page 16 – EMERGENCY DISARM WITH CUSTOM OVERRIDE
- Page 17 – IGNITION-CONTROLLED DOORLOCKS; Doors will not lock if they are open to; VEHICLE OPERATION; VEHICLE CONTROL
- Page 18 – CARJACK PROTECTION FEATURES; ACTIVE CARJACK
CS-2001FC Series II
REMOTE CONTROL ALARM SYSTEM
INSTALLATION & OPERATING INSTRUCTIONS
INTRODUCTION
CONGRATULATIONS
on your choice of a Gargoyle™ Remote Alarm System by Crimestopper Security
Products Inc. This booklet contains the information necessary for installing, using, and maintaining your alarm
system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the
Tech Support number below.
*IMPORTANT INFORMATION: Primary and Optional Features:
-PRIMARY:
These are features that must be connected in order for the system to operate properly; i.e. the
Siren, L.E.D., +12V Power, Ground, Doorpin, Override/Program/Valet Button etc.
-OPTIONAL:
These are features to be connected if desired or agreed upon by the installing dealer. These
features may also require additional parts and/or labor fees. Consult with your installer beforehand; i.e. Door
Locks, Flashing Lights, Starter disable, Hood/Trunk trigger, and Auxiliary Remote Outputs etc.
This device complies with FCC Rules part 15. Operation is subject to
the following two conditions: 1) This device may not cause interference,
and (2) this device must accept any interference that may be received,
including interference that may cause undesired operation. The
manufacturer is not responsible for any radio or TV interference caused
by unauthorized modification to this equipment. Such modification
could void the user's authority to operate the equipment.
TECH SUPPORT
Mon-Fri 8:00 AM-4:30 PM Pacific Time
(800) 998-6880
REV
B
5
/2003 SW: CF
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TABLE OF CONTENTS Installation Cautions & Warnings…….……………………………….………………………………………………2 Control Module & Component Mounting……………...………………………..……………………….…………..3 Wiring……..……………………………………………………………………………………………………….…….3-6 Parking Light Jumper Diagram………………………………………………….………………………….…..……..5 Power Doo...
CONTROL MODULE & COMPONENT MOUNTING DO NOT Mount the control unit in the engine compartment or where the control unit or wiring harness where they can become entangled with moving parts such as brake/gas/clutch pedals, or the steering column! The alarm control module should be mounted in a conce...
WIRING BLACK WIRE: SYSTEM CHASSIS GROUND The Black wire MUST be connected the CHASSIS METAL of the vehicle. Scrape away any paint or debris from the connection point and use a star washer to ensure a good connection. Keep the ground wire short. YELLOW WIRE: IGNITION SWITCHED “ON” AND “START” +12 VOL...
