Samsung SHR-3010P - Manuals

Samsung SHR-3010P Sound Bar – User Manual in PDF format online.

Manuals:

User Manual

User Manual Samsung SHR-3010P

Summary

Page 2 - Important Safety Instructions; CAUTION

GB iii GB ii DIGITAL VIDEO RECORDER Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in acco...

Page 3 - Contents

Contents iii v 1 2 3 1-1 1-2 1-3 1-7 1-8 2-1 2-2 2-3 2-4 3-1 3-4 3-9 3-14 3-15 3-18 3-22 3-23 3-24 3-25 3-26 iv iv v Important Safety Instructions Contents I. Summary 1. Introduction 2. Characteristics 3. Name and Function of Each Part 4. Unpacking 5. HDD Addition II. Connection with Other Devices 1...

Page 5 - Introduction

1-2 GB 1-1 DIGITAL VIDEO RECORDER 1 Introduction 2 Characteristics The Digital Video Recorder SHR-3010 is a Digital Time Lapse Recorder to utilize its HDD as a recording media. How to use it is simple and therefore existing users of Time Lapse VCR can also access to it since it is built with Jog/Shu...

Page 6 - Name and Function of Each Part; Front View

No Name Function DOWN ( ) SET/STILL ( ) RIGHT ( ) PLAY ( ) RECORD ( ● ) REC LOCK( ) STOP ( ■ ) JOG/SHUTTLE ( / ) Used when moving cursor to the lower item of menu orreducing values in setting-up details of menu. Used when temporarily stopping during play or desiring to seestill screen. Plays a role ...

Page 7 - Rear View

GB 1-6 GB 1-5 DIGITAL VIDEO RECORDER Rear View 1 2 3 4 5 No Name Function EXTERNAL I/O PORT FAN AC IN POWER ● ALARM IN: In the N.C. (Normally Closed) mode, the system recognizes an alarm when a High (5V) signal is input for over 0.5 seconds. In the N.O. (Normally Open) mode, the system recognizes an...

Page 8 - Unpacking; Mounting HDD; Caution

Caution Caution The above contents can be changed without notice in order to improve theperformance or function of the product. 1-7 1-8 DIGITAL VIDEO RECORDER 4 Unpacking GB GB 5 HDD Addition When purchasing product, first remove packing and put it on a flat floor or at a place to use it. Then, ensu...

Page 9 - Mode setup and cable connection

GB 1-10 GB 1-9 DIGITAL VIDEO RECORDER Mode setup and cable connection Set a HDD mode and connect cables after mounting the HDD to product. Below is shown drawing of Power Connector and AT-Bus Interface Connector and Configuration Jumper Block of HDD. Setting of HDD mode is performed in a Configurati...

Page 10 - Other Devices

Page 12 - System Connection for Alarm Recording; Connection with RS-232C

2-3 2-4 DIGITAL VIDEO RECORDER 3 System Connection for Alarm Recording GB GB 4 Connection with PC for Use <Rear Side Connection Terminal of SHR-3010> <Outside Product> ALARM IN ALARM RESET ALARM OUT TRIGGER OUT GND ■ Alarm recording is a function for recording the input video when an ala...

Page 13 - Connection with RS-485

GB 2-6 GB 2-5 DIGITAL VIDEO RECORDER Connection with RS-485 Remote control is allowed through connection with RS-485 (up to 1.2km). A. Communication method ● Data transmission method: Start-Stop Synchronized Serial Interface ● Protocol: 8 bit Data, 1 Stop bit, None Parity ● Transmission speed: 4800,...

Page 14 - to use

Page 15 - Booting the System; Power On; Recognizing incoming video signal

3-2 GB 3-1 DIGITAL VIDEO RECORDER 1 Booting the System Power On There is a power switch on the upper right hand side behind the system. Pull the powerswitch up to boot the system. Then, the LED on front of the system is turned on, a bluescreen with the following message will appear and the system is...

Page 16 - Power Off; Basic Screen Viewing; Viewing Full Screen

3-4 GB 3-3 DIGITAL VIDEO RECORDER GB Power Off Push the power switch down in order to turn off the system.When the system power is turned off during recording, recording will be resumed next timethe system power is turned on and booting is complete. Caution Caution Wait at least 3 seconds after turn...

Page 17 - Live Screen Viewing

3-6 GB 3-5 DIGITAL VIDEO RECORDER GB It shows the current date and time as configured by the system. You can change the display position of date and time. You shall designate the position in the top right or left corner by yourself. (Just choose LEFT or RIGHT in the CLOCK/DISPLAY MODE SETUP menu. Pl...

Page 18 - Playback screen Viewing

3-8 GB 3-7 DIGITAL VIDEO RECORDER GB Playback screen Viewing The normal Playback screen looks like this. Viewing Screen during recording The normal recording screen looks like this. 2001-08-22 18:19:12 If the system is executing the recording function, icon blinks. If the system is in the recording ...

Page 19 - Change of Settings; Menu Enter; Menu View; Note

3-10 GB 3-9 DIGITAL VIDEO RECORDER GB Change of Settings ① Move to desired menu item by using an UP( ) or a DOWN( ) button. ➁ You can change settings by pressing the SET/STILL( ) button. ➂ Press the UP( ) or DOWN( ) button in order to change settings. ➃ Settings will be changed if pressing the SET/S...

Page 20 - Example of menu setting (in case of changing time)

3-12 GB 3-11 DIGITAL VIDEO RECORDER GB ➃ Similarly, press the UP( ) or DOWN( ) button so current minute is displayed. Then if pressing the LEFT( ) or RIGHT( ) button, the cursor is changed so hour or second is changed. For example, press the RIGHT( ) button to change seconds and setup by pressing th...

Page 21 - Setting of Date, Time and Screen; Each menu item

3-14 GB 3-13 DIGITAL VIDEO RECORDER GB 4 Setting of Date, Time and Screen The following illustrates the intial setting of the CLOCK/DISPLAY MODE SETUP menu. ① DATE Set the current date. ② TIME Time can be entered in the form of 24 hours. ➂ DATE DISPLAY TYPE There are 3 date forms to be displayed. Yo...

Page 22 - Record Setup

3-16 GB 3-15 DIGITAL VIDEO RECORDER GB Note Note The following table shows how long it takes to fill the 40GB HDD with respect to each fieldrate when the video signal is NTSC and PAL respectively.(Recording time for each field rate may slightly vary depending on the type of inputvideo singal.) ➃ DIS...

Page 23 - Alarm Record Setup

3-18 GB 3-17 DIGITAL VIDEO RECORDER GB 6 Alarm Record Setup The following illustrates the intial setting of the ALARM RECORD SETUP menu. ① ALARM ENABLE You shall select ON to start recording in the event of alarming and select OFF to preventrecording in the event of alarming. If you set the ALARM EN...

Page 25 - Reservation Record Setup

3-22 GB 3-21 DIGITAL VIDEO RECORDER GB 7 Reservation Record Setup The following illustrates the intial setting of the TIMER RECORD SETUP menu. ● Timer recording enables the system to automatically record when you are not present so thatthe recording is performed on the desired day at the desired tim...

Page 26 - Communication Setup; System Setup

3-24 GB 3-23 DIGITAL VIDEO RECORDER GB 9 Communication Setup The following illustrates the intial setting of the COMMUNICATION SETUP menu. ① BAUD RATE Sets data transmission rate in RS-232C communication. [4,800/9,600/19,200/38,400/115,200] ② NETWORK ACCESS/IP ADDRESS/GATEWAY/SUBNET MASK If the syst...

Page 27 - System Information

3-26 GB 3-25 DIGITAL VIDEO RECORDER GB 11 Backup Setting (SCSI HDD BACKUP) You shall connect this DVR to an external SCSI HDD with a connector to backup or replay the video or audio signal stored in the main body HDD. The external SCSI HDD is the only backup device of this DVR. Here comes the BACKUP...

Page 32 - Basic Record

4-2 GB 4-1 DIGITAL VIDEO RECORDER 1 Basic Record Basic Record ① CURRENT IMAGE RECORD Press the RECORD( ● ) button to record current image. If doing so, the light of the RECORD( ● ) button turns on and record starts while following message appears on the screen. Settings related with record are done ...

Page 33 - Record Lock

4-3 4-4 DIGITAL VIDEO RECORDER 2 Record Lock GB GB 3 Alarm Record Record Lock Press the REC LOCK button during recording to lock the recording. Then, the LOCK status indicator LED and the REC LOCK button will light up. At this time, pressing the STOP( ■ ) button will not stop the recording. An icon ...

Page 34 - Playback; Reservation Record

V. Retrieval and Playback 5 4-5 DIGITAL VIDEO RECORDER 4 Reservation Record GB Reservation Record Setup You can enter the day, time, and field rate for the timer recording in the TIMER RECORD SETUP menu so that the recording will be made on the set day for the set amount of time. Reservation Record ...

Page 35 - Retrieval Menu View; Retrieval Menu Enter; Upper Menu Move and Menu End

5-2 5-1 DIGITAL VIDEO RECORDER 1 Retrieval Menu View Retrieval Menu Enter Press the SEARCH button to retrieve recorded data. If doing so, following screen appears. Menu Move Use the UP( ) or DOWN( ) button to move to the desired menu item. At this time, a highlighted cursor is shown by the selected ...

Page 36 - Retrieval by Date and Time

5-3 5-4 DIGITAL VIDEO RECORDER 2 Retrieval by Date and Time GB GB Following screen appears and light of the PLAY( ) button flickers if pressing the SET/STILL( ) button after entering date and time to retrieve and placing the cursor at search. You can play retrieval data if pressing the PLAY( ) butto...

Page 37 - Alarm Record Retrieval; Power On/Off Status List View

5-5 5-6 DIGITAL VIDEO RECORDER 4 Alarm Record Retrieval GB GB Among the data on the HDD, the ones that were recorded when a motion was detected or alarm was triggered will be displayed as a list based on the recording start time. Other information is same as in “3. Recorded Data List View” on p. 5-4...

Page 38 - Basic Playback

5-7 5-8 DIGITAL VIDEO RECORDER 6 Basic Playback GB GB Press the PLAY( ) button to immediately play back the data recorded on the HDD. Then, the PLAY ( ) button lights up, the following screen appears, and the beginning of the recorded data is played back in turn. To stop the playback, press the STOP...

Page 39 - Various Screen View Using JOG/SHUTTLE; Play in Various Speed

Temporay Stil Screen View Press the SET/STILL( ) button during playback. (For details on the pause mode, refer to “6. Basic Playback” on p. 5-7.) View by Field In order to view still images one field at a time, press the RIGHT( ) or LEFT( ) but- ton during the pause mode, or turn the JOG( ) during t...

Page 41 - Product Standards; Appearance Drawing

6-2 GB 6-1 1 Product Standards Rated Voltage AC 110 ~ 240V, 50/60 Hz Power Consumption 26W HDD 80 GB Basic Installation (Simultaneous Installation of Max. 2 HDDs) BACKUP External SCSI II Interface(SCSI HDD) Video Input Composite Video, BNC Jack - 1CH (1.0 Vp-p, 75 Ω ) Video Output Composite Video, B...

Page 43 - Check Points before Call Service Center

7-2 GB 7-1 1 Check Points before Call Service Center DIGITAL VIDEO RECORDER If the system malfunctions, please check the following instruction before you call the service center or the shop where you bought the system. Trouble Check Points • Unable to supply power. • The POWER LED in front of the sy...