Pelco DX8000-UPDVD - Manuals

Page 2 - Protecting people and property in a million locations worldwide.

Protecting people and property in a million locations worldwide.

Page 3 - Introduction; PARTS LIST; TOOLS NEEDED

C1604M (6/04) 1 Introduction The following instructions serve as an installation guide for the DX8000-UPDVD drive kit. PARTS LIST NOTE: This upgrade kit includes a Pelco-certified DVD-RW drive. Using any other drive voids the manufacturer’s warranty for the DX8000. Qty Description 1 DVD-RW drive 2 M...

Page 4 - Getting Ready

2 C1604M (6/04) Getting Ready 1. Familiarize yourself with the instructions throughout this manual. 2. Check that you have all the necessary parts and tools. Refer to the Parts List and Tools Needed section. 3. Shut down the DX8000 Series DVR unit. Refer to DX8000 Installation Manual or Operations a...

Page 7 - Prepare Unit for Drive Installation; OPEN THE UNIT CHASSIS

C1604M (6/04) 5 Prepare Unit for Drive Installation OPEN THE UNIT CHASSIS WARNING: The chassis assembly includes parts with sharp edges. To avoid injury, use caution when working in and around the DX8000’s chassis and components. 1. If the DX8000 is mounted in a rack, remove it and transport it to a...

Page 10 - COMPONENT LAYOUT

8 C1604M (6/04) COMPONENT LAYOUT Figure 6 shows the location of your DX8000 Series DVR’s major components. Certain cables and components have beenomitted from the illustrations in this manual for the purpose of clarity. POWER SUPPLY DIMM SOCKETS (RAM) CPU VGA CARD PCI SLOT 1 2 3 4 5 6 REAR CROSS-BRA...

Page 11 - Remove the Existing Optical Drive; DISCONNECT THE CD/DVD DATA CABLE AND POWER WIRES

C1604M (6/04) 9 Remove the Existing Optical Drive DISCONNECT THE CD/DVD DATA CABLE AND POWER WIRES When removing data cable and power wires, pull the connectors straight out. Do not rock connectors back and forth orremove a connector by pulling it by its wires or cable. 1. Remove the IDE data cable ...

Page 13 - REMOVE THE CD/DVD DRIVE

C1604M (6/04) 11 REMOVE THE CD/DVD DRIVE 1. Using a Phillips-head screwdriver, unfasten the two screws that attach the CD/DVD to the chassis. Refer toFigure 9. Figure 9. Removing CD/DVD Mounting Screws 1

Page 15 - Install the New DVD-RW Drive into the Unit

C1604M (6/04) 13 Install the New DVD-RW Drive into the Unit 1. Insert the new DVD-RW into the DVR: a. Make sure the drive is oriented correctly. b. Insert the new DVD-RW into the DVR through the front of the unit. Refer to Figure 11. Figure 11. Inserting the New DVD-RW Drive 1b DVD-RW

Page 17 - RECONNECT THE DATA CABLE AND POWER WIRES

C1604M (6/04) 15 RECONNECT THE DATA CABLE AND POWER WIRES IMPORTANT : Data and power connectors fit together only one way. All connectors are keyed to ensure that they are inserted in the proper orientation. Examine the drive, motherboard and cable connectorsbefore installation so that connectors ar...

Page 19 - Reassemble the Unit

C1604M (6/04) 17 Reassemble the Unit 1. Using a Phillips-head screwdriver, reattach the side panel you removed earlier. Refer to Figure 15. Figure 15. Replacing Side Panel

Page 22 - Notes