Nortel 100 Series - Manuals

Page 2 - ii; Trademarks

ii 893-00978-A 4401 Great America Parkway 8 Federal Street Santa Clara, CA 95054 Billerica, MA 01821 © 1996 by Bay Networks, Inc. All rights reserved. Trademarks Bay Networks, BayStack, and SmartSwap are trademarks of Bay Networks, Inc. Other brand and product names are registered trademarks or trad...

Page 3 - Introduction; BayStack

893-00978-A 1 Introduction This document outlines the procedure for upgrading the boot firmware for the Bay Networks ™ BayStack ™ 100-series network management module (NMM). If you are using the version 1.5 agent for the BayStack 100-series NMM, revision D boot firmware is necessary to enable the fo...

Page 4 - Package Contents; Upgrade Instructions for the BayStack 100-series; Required Tools; If the hub is installed in a rack, remove it.

Upgrade Instructions for the BayStack 100-series Version D Boot Firmware 2 893-00978-A Package Contents The BayStack 100-series NMM Version D Boot Firmware upgrade kit contains the following components: • A boot PROM for the type of NMM you have: – Bay Networks part number CG1011003 for Basic NMMs –...

Page 5 - Disengaging the NMM from the hub; Slide the NMM out of the expansion slot.; Accessing the NMM Baseboard; Figure 2; DCM attachment screws on a BayStack 100-series NMM

893-00978-A 3 5. Using a #1 Phillips screwdriver, remove the screws from the NMM faceplate in the hub expansion slot. 6. Rotate the extractor lever to its unlocked position (see Figure 1 ). Figure 1. Disengaging the NMM from the hub 7. Slide the NMM out of the expansion slot. Accessing the NMM Baseb...

Page 6 - Removing and Replacing the PROM; To replace the PROM on the NMM baseboard, follow these steps:; Find the PROM in location U2 on the NMM baseboard (see; PROM location on the NMM baseboard; The PROM socket may not always be in the same orientation to the

Upgrade Instructions for the BayStack 100-series Version D Boot Firmware 4 893-00978-A 2. Gently disengage the DCM connector from the NMM connector and lift the DCM off of the NMM. Set the DCM aside. Be sure to keep the screws with the DCM so that you can use them again later. Removing and Replacing...

Page 7 - Be careful that the extraction tool you use does not bend or put

893-00978-A 5 2. Remove the PROM. a. Use an industry-standard IC extraction tool to firmly clamp the sides of the PROM. b. With the extraction tool in place, pull straight up on the PROM until it disengages from its socket. 3. Install the new PROM. a. Grasp the sides of the PROM between your thumb a...

Page 8 - Replacing an NMM in a BayStack Hub; To replace an NMM in a BayStack 100-series NMM, follow these steps:; Figure 4; Installing the NMM into the expansion slot; For BayStack products that do not have power switches, the power

Upgrade Instructions for the BayStack 100-series Version D Boot Firmware 6 893-00978-A Replacing an NMM in a BayStack Hub To replace an NMM in a BayStack 100-series NMM, follow these steps: 1. Align the left edge of the NMM metal frame with the card guides on the left side of the expansion slot (see...