National Instruments NI UES-3880 - Manuals

— 6 — You should also pay attention to the following items: y Use separate paths to route wiring for power and devices. If power wiring and device wiring paths must cross, make sure the wires are perpendicular at the intersection point. y NOTE: Do not run signal or communications wiring and power wi...

— 7 — Top View Front View STEP 1 : Insert the negative/positive DC wires into the V-/V+ terminals. STEP 2 : To keep the DC wires from pulling loose, use a small flat-blade screwdriver to tighten the wire-clamp screws on the front of the terminal block connector. STEP 3 : Insert the plastic terminal ...

— 8 — RJ45 (8-pin) to RJ45 (8-pin) Cross-Over Cable Wiring Cross-Over Cable RJ45 Plug Pin 1 Switch Port(NIC Port) RJ45 Connector RJ45Connector Tx+Tx-Rx+Rx- (Rx+)(Rx-)(Tx+)(Tx-) (Tx+)(Tx-)(Rx+)(Rx-) Switch Port(NIC Port) Cable Wiring 3 1 6 2 1 3 2 6 Rx+Rx-Tx+Tx- Redundant Power Inputs Both power inpu...

— 9 — LED Indicators The front panel of the NI Switch contains several LED indicators. The function of each LED is described in the table below. LED Color State Description On Power is being supplied to power input PWR1 PWR1 AMBER Off Power is not being supplied to power input PWR1 On Power is being...

— 11 — Specifications Technology Standards IEEE802.3, 802.3u, 802.3x Forward and Filtering Rate 148810 pps Packet Buffer Memory 256 KB Processing Type Store and Forward, with IEEE802.3x full duplex, back pressure flow control Address Table Size 1K uni-cast addresses Latency Less than 5 μ s Interface...