Epson ELPMB30- Manuals

5 Carefully read the warnings in "Safety Instructions / Support and Service Guide" supplied with your projector before starting the installation to determine a suitable place to install it. In particular, pay attention to the following. v Avoid installing the projector in a place where the r...

6 Installing the Ceiling Plate and Ceiling Plate on the Ceiling Determine the distance to the screen and locate the mounting position before mounting the ceiling plates. Refer to "Ceiling template" below for the size of the ceiling plate and the location of screw holes and their size. Be car...

7 B Remove the tape which secures the ceiling plate and the ceiling plate . Then loosen the screws (not until they come off) that secure the plates with the ball point hex wrench. C Attach the ceiling plate and ceiling plate on the ceiling. Set the cutouts to the screen. Take care not to catch the c...

10 Mounting Projector Plate on the Projector A Set the projector plate on the projector as shown in the figure, and align the screw holes on the plate with the projector's screw holes for the ceiling mount. * When installing the projector plate on the EH-R4000/R2000/ R1000, the installation directio...

11 Mounting the Projector Plate to the Ceiling Plate A Insert the projector plate through the cutouts on the ceiling plate . B Slide the projector plate and engage the dowels on the projector plate into the cutouts on the ceiling plate . Necessary items for the following procedure Y M4x10 screws (mm...

13 If the projected image is not fit to the screen, adjust the projection position as follows. v Adjustment by the Lens Shift (for projectors with the lens shift function only) Adjust the projection position by the lens shift function of the projector. For the details on the lens shift, refer to ...

14 Shifting the Projected Image Up or Down A If the screws are tightened, slightly loosen the four screws using the ball point hex wrench. B Raise or lower the projector manually and roughly adjust the projection position. You can fine tune the position downwards in Step 4, so adjust the position sl...

16 Shifting the Projected Image to the Right or Left A If the screws are tightened, loosen the two screws using the ball point hex wrench. B While tightening the screws with the ball point hex wrench, fine tune the position. Procedure v Keep holding the projector until the installation is complete. ...

17 Adjusting the Projected Image's Horizontal Roll A If the screws are tightened, slightly loosen the two screws using the ball point hex wrench. B Adjust the angle by turning the adjustment dial or adjustment dial . Adjustment dial : Lowers the right side of the projected image. Adjustment dial : L...

18 Install the ceiling plate cover after adjusting the installation angles as necessary if you want to coordinate the colors of the projector and the ceiling. A Insert the ceiling plate cover to the rear side. Use the piece with a cutout to cover the rear side. B Insert the M4x10 screws into the scr...

19 C Insert the other piece for the screen side and fit it to the ceiling plate cover for the rear side. D Insert the M4x10 screws into the screw holes on the ceiling plate cover and tighten them with the ball point hex wrench. Removal, installation, and adjustment for repair or maintenance of the p...